2. Oneida Air Systems
  3. AXD000009

Oneida Air Systems AXD000009 Operating instructions

  • Hello, I'm your chat assistant. I've reviewed the user guide for modifying the Ultimate Dust Deputy 9 gallon waste bin, specifically how to trim the lugs to fit Festool Mini and Midi dust extractors. I am ready to assist with your questions about this process. The document provides detailed step-by-step instructions and illustrations for this modification.
  • What tool can be used to trim the lugs?
    How much material should be removed initially?
    What should be done after trimming one lug?
How to modify the Ultimate Dust Deputy
collection box to t your Festool Mini or Midi.
Fig. 1
Fig. 2
The Ultimate Dust Deputy 9 gallon waste bin box lugs may need to be trimmed for the bin to properly
t Festool Mini and Midi dust extractors. Detailed instructions are shown below.
Using a sharp wood chisel, a hand grinder, or other suitable tool, carefully trim o the inside of the
lug where indicated by the “X” in Fig. 1. First remove a small amount of material and then test the t.
Repeat as necessary until the clamp locks securely. Repeat the procedure on the opposite lug until
the clamp on that side locks securely. Fig. 2 shows a completely trimmed lug.
If you have any further questions, please call Oneida Air Systems Customer Service at 1.866.387.8822.
Ver. 2_25_20
/