Thermo Fisher Scientific VisionMate High-speed reader software Operating instructions

Hello, I've reviewed the instructions for upgrading the Thermo Scientific VisionMate High-speed reader software. This document provides steps for software and driver installation, including those for the AB-1860 1D barcode reader. I'm ready to answer your questions.
What should I do before installing the new software?

What to do if Windows logo testing has not been done?

What to do after plugging in the scanner?

What is required for the AB-1860 1D bar code reader accessory?

75 Panorama Creek Drive Rochester, NY Tel: 585.586.8800 www.thermofisher.com

14625

Fax: 585.586.3294

Instructions for Upgrading the Thermo Scientific VisionMate High-speed

reader software

1. Download the updated software version (follow below link for software download).

2. Unplug the scanner from your computer.

3. Double click on the executable and allow the software to install.

4. Select "yes" if/when you get the notification stating Windows logo testing has not been done.

5. When prompted, plug in the scanner and allow the camera drivers, USB hub and dongle to

install, and click ok once all three of the driver installations have completed. (Takes about five

minutes.)

6. Restart computer and test software.

If you are utilizing the AB-1860 1D (linear) bar code reader accessory, High-Speed software

versions 3.1.1.30 and higher require a newer version of the 1D software. To download the latest

version, follow the link below.

http://www.thermoscientific.com/ecomm/servlet/newsdetail_11152_53158_-1