2. LC-Power
  3. LC-CC-124-ARGB-TB

LC-Power LC-CC-124-ARGB-TB Owner's manual

  • Hello! I have reviewed the user manual for the LC-CC-124-ARGB-TB CPU cooler. This document provides detailed instructions on how to install the cooler on both Intel and AMD platforms, apply thermal paste, and connect the fan and RGB lighting, along with wiring diagrams. I'm ready to answer any questions you have about the product and its installation.
  • What is the first step of cooler installation?
    What should be done after removing the transparent sheet?
    Where should the 4pin PWM connector be connected?
    What is a digital RGB adapter cable (D) and when should I use it?
Step 1- Installation
1. Remove the transparent sheet from the cooler and the CPU bottom.
Now spread some thermal paste evenly on the CPU.
2. Clip two sides to each corresponding bracket.
3. Connect the cooler fan and the illuminated outer ring to the mainboard.
Step 2- Fan and wire connection
1. Connect the 4pin PWM connector to the mainboard -> “CPU FAN”
2. Connect the 3 pin digital RGB fan cable (B) with the mainboard.
Consult your mainboard manual to locate the position of the RGB connector on
your mainboard. Colours and modes can be controlled via the mainboard's RGB
software (digital RGB/ARGB).
B
CD
A
LGA775 LGA115X
CPU thermal paste
CPU
Intel
AMD AMD FM1/FM2/AM2/AM2+/AM3/AM3+/AM4
TM
Silent Power Electronics GmbH,
Formerweg 8, 47877 Willich,
Germany, www.lc-power.com,
Email: support@lc-power.com
TM
LC-CC-124-ARGB-TB
thermal paste
3. Some mainboards need the digital RGB adapter cable (D) which must be connected
between the 3 pin RGB fan cable (B) and the mainboard itself.
So connect the adapter (C) to the 3 pin digital RGB fan cable (B). And now (D) to
the mainboard.
/