Accusplit AX850 Operating instructions

Type
Operating instructions
AX850 PACE CLOCK
Operating Instructions
Installing the Battery
1. Remove the battery door in back by pushing tab
down and pulling toward you. The adjustment knob
(with stem) will be attached to the door when opened.
2. First, insert LR6 (AA) battery with + (Positive) end into
left end, then be sure copper switch plate (end tip of
wire) is between – (Negative) end of battery and
– (Negative) side of battery holder and press battery
into position.
3. Reinstall door being careful to reinsert the adjustment
knob stem into motor slot. (The stem can be separated
from knob head, inserted into motor slot, replace door
with stem protruding thru door hole and attach knob
head to stem).
Operating the Clock
To start or stop the clock, press the red button on top right of the unit.
Setting & Resetting the Clock
To set clock, turn the adjustment knob in the back door until the clock
face shows desired time. The adjustment knob controls the black min-
ute hand only. The red second hand is controlled by the Start/Stop but-
ton. Use the Start/Stop button to move it into desired starting position.
Normally, users set the clock back to zero before use. Alternatively,
you can set the clock to a specic time
to provide a timing interval.
(For example, to time a 20 minute
interval, set the minute hand
at 40 and start the clock.
When the clock (minute
hand) reaches 60, your
20 minute interval is up.)
Start/stop button
Minute hand
Second
hand
Direction of
counting
Motor slot
+ –
800-935-1996 • 925-290-1900 • FAX 925-290-1930
www.ACCUSPLIT.com • support@ACCUSPLIT.com
Adjustment knob
for setting/resetting
To open
battery door
push down here
Copper
switch
plate
AA cell
The AX850 is a large-format pace clock suitable for in-
door and outdoor use. It is a “count up” timer with one
second resolution to 60 minutes. The clock continues
to count after passing 60 minutes each time.
Base
Extension
For Windy Conditions
The AX850 has a base extension that will help keep the unit upright
in windy conditions. The extension is built into the base of the unit.
To use the extension, tilt unit upwards so that the face is pointing
towards the ground. Loosen wing nut on base extension and slide it
out towards back of unit.
Note: Put a heavy object on top of the extension for even more
stability.
Specifications:
Analog, clock-style display with 15" face
Count up from zero to 60 and repeat
Rugged ABS plastic case designed for outdoor use
Safe for use in damp & wet environments
(Do not submerge)
Push button on/off
Repair Procedure:
The following repair kits available for self repair.
AX850KITBASE: Base Replacement Kit (Base And Screw)
AX850KITCH: Clock-Hand Replacement Kit
(Handset, Seiko Clock Movement And Switch)
AX850KITFACE: Face Replacement Kit (Clear Lens And 4 Screws)
800-935-1996 • 925-290-1900 • FAX 925-290-1930
www.ACCUSPLIT.com • support@ACCUSPLIT.com
AX850KITCH
AX850KITFACE
5 YR. PROOF-OF-PURCHASE LIMITED WARRANTY
After 90 days, service available for a small fee
until at least 5 years after date of purchase.
See details at support@ACCUSPLIT.com
AX850KITBASE
103-1507
  • Page 1 1
  • Page 2 2

Accusplit AX850 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI