Signature Hardware SH416178 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
SH416178
Category
Sanitary ware
Type
Installation guide
1Knox Roman Tub Faucet Installation Instructions
KNOX ROMAN TUB FAUCET
Before installing, read entire Knox Roman Tub Faucet Installation Instructions. Observe all local building and safety
codes.
For the following installation instructions for your new faucet it is assumed that any old xtures have been removed and
any repairs or modications to the water supply have been completed.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1-866-855-2284. If you need assistance or have questions while installing your faucet, contact Customer
Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures. Signature Hardware
accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.
TOOLS AND MATERIALS:
Adjustable WrenchScrewdriver Allen Wrench
SPECIFICATIONS:
1/2"1/2"
4" 4"
1-1/4" min1-1/4" min
4-1/4"
1-1/2" max
1-1/4" min
2Knox Roman Tub Faucet Installation Instructions
1. Loosen the M5 screws to remove the handle levers,
spacing rings, clamp rings, and escutcheons from
the inlet valves. Move the locking nut down on the
threaded portion of the handle valves.
Handle Lever
Handle Escutcheon
Lock Sleeve
Clamp Ring
M5 Screw
Spacing Ring
Locking Nut
Locking Washer
Rubber Washer
Inlet Valve
Tub Deck
Outlet
Outlet
2. From beneath the tub deck, feed the handle valves
through the mounting holes. Thread the handle
escutcheons, clamp ring, and lock sleeve onto the
valves.
3. Remove locking nut, locking washer and rubber
washer from the faucet body.
4. Place the faucet body through the tub deck. Thread
the rubber washer, locking washer, and locking nut
onto the faucet body and tighten with an adjustable
wrench.
Faucet Body
Locking Nut
Locking Washer
Rubber Washer
Lagging
Fastening Screw
3Knox Roman Tub Faucet Installation Instructions
6. Connect the inlet valves and tee joint with the
connection tubes and tighten the coupling nuts.
5. Attach the tee joint to the faucet body.
8. When your faucet installation is complete, turn on
the water supply. Check to make sure that all
connections are tight (no water should be leaking)
and that the hot and cold supplies are working
correctly. Turn the water on and allow the water to
ow through the spout for approximately 60 seconds.
7. Tighten the locking nut and fastening screw.
Reinstall the plastic spacing ring and handle lever.
Tighten the M5 screw to secure.
Fastening Screw
Tee Joint
1/2" O-ring
Coupling Nut Connection Tube
1/2" O-ring
Washer
  • Page 1 1
  • Page 2 2
  • Page 3 3

Signature Hardware SH416178 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
SH416178
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents