4
Assembly
1
Assembling the posts
2
Attaching the bottom shelf
□ Screw the top post assembly (C) into the bottom post
assembly (B) until secure.
□ Repeat this procedure for the remaining posts (B & C).
NOTE: More than one person may be required for this
step.
□ Locate the desired position where the lowest shelf will be
installed onto the post assemblies.
□ Insert a plastic sleeve (A) into the appropriate groove on
each bottom post assembly (B). Ensure the tapered end of
the plastic sleeve (A) is facing up towards the top post (C).
□ Place the shelf (D) on its side, and slide the post assemblies
up through the bottom of the shelf (D), beginning with the
top post (C), until the shelf (D) is firmly seated on the plastic
sleeves (A).
□ After the shelf (D) is in place, turn the unit to the upright
position.
□ Push down on each corner of the shelf (D), ensuring it is in
the fully locked position.
3
Attaching additional shelves
4
Leveling the unit
□ Locate the desired position of the next lowest shelf (D), and
insert the plastic sleeves (A) into the appropriate grooves
on the post assemblies.
□ Slide the shelf (D) down from the top of the post
assemblies and onto the plastic sleeves (A). Push down on
each shelf (D) corner, ensuring that it is firmly seated on
the plastic sleeves (A).
□ Repeat this procedure for the remaining shelves (D).
NOTE: The bottom post assemblies (B) have foot levelers
pre-installed into the bottoms.
□ Screw the pre-installed foot levelers clockwise or
counterclockwise until the unit is level.