l
Operation using the advanced key/
retractable type key
Programmed seat positions can activated
using the following functions:
l
Programming buttons 1, 2, or 3.
l
Operation using advanced keyless
functions/keyless entry system
NOTE
Individual seat positions can be programmed
to the three available programming buttons on
the side of the driver's seat, plus one seat
position for each advanced key/retractable
type key used with the vehicle.
Operation using the seat-side buttons
Programming
Park the vehicle in a safe location before
performing the seat position
programming. (Vehicle must be stopped)
1. Adjust the seat to the desired position.
For each seat position adjustment
method refer to the following pages:
Seat Slide (page 2-5)
Seat Recline (page 2-5)
Height Adjustment (page 2-6)
2. Press the desired programming button
1, 2, or 3 while pressing the set button
until a beep sound is heard.
The button is programmed after a beep
sound is heard. Other buttons can be
programmed using the same procedure.
NOTE
Vehicle maintenance or other reasons
requiring the vehicle battery to be
disconnected will result in the seat position
memory being erased.
In this case, re-program the seat positions.
Setting the driver's seat to a pre-
programmed position
There are two methods for setting the
driver's seat to a pre-programmed
position. For example, the type A method
can be used before sitting in the seat and
while the driver's door is open, and the
type B method can be used after getting in
the vehicle with the driver's door closed.
TYPE A
When the ignition switched off and the
driver's door is open, press the
programming butt on 1, 2, or 3 for the
desired seating position.
NOTE
In the following cases, the seat position set
function cancels:
l
Any of the seat adjustment switches are
operated.
l
The set switch is pressed.
l
A programming button 1, 2, or 3 is pressed.
l
The vehicle starts moving.
l
Vehicle locking/unlocking is done using the
transmitter.
l
Vehicle unlocking is done by pressing the
request switch on a front door while the
advanced key is being carried.
l
Vehicle unlocking is done by touching the
sensor area on the backside of the front
door handle while the advanced key is
being carried.
TYPE B
When the ignition is switched ON or the
driver's door is closed, press and hold the
desired programming button 1, 2, or 3.
Essential Safety Equipment
Seats
2-7
Mazda6_8AS2-EC-09E_Edition1 Page19
Monday, June 1 2009 3:56 PM
Form No.8AS2-EC-09E