LCD Monitor &
CCD Color Camera
Hummer
H2–2003-2004
Installation Manual
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584
www.vizualogic.com
Copyright © 2003 TMI Products, Inc.
All Rights Reserved
Corona, CA U.S.A.
060300
99-8019-002 10/03
Backup Monitor System
Backup Monitor System
Fall 2003
Monitor Installation
1. Locate the center console on the front part of the headliner.
2. Remove the (2) Phillips screws from the center console and slide
towards the front of the vehicle.
3. Insert the monitor cable through the opening in the headliner
and route to the A-pillar.
4. Pop out the (2) clips holding the handle to the driver side A-pillar.
(Fig.2)
5. Remove the handle and plastic shroud A-pillar.
6. Route the monitor cable from the headliner to the A/V Control
Module located under the seat or alternate location.
7. Insert the Monitor Cable into the opening on the backside of the
Monitor Housing.
8. Connect the Monitor Cable to the LCD Monitor.
9. Screw the LCD Monitor onto the Monitor Housing using the (2)
provided screws.
10. Secure the rear-hooks of the Monitor housing to the top of the
console. (Fig. 3)
Fig. 1 Fig. 2 Fig. 3
6. Remove the panel located above the bumper inside the back of
the vehicle.
7. Drill a
1
⁄2” hole under the center of
the panel for routing the wire in
the vehicle. (Fig. 2)
8. Route the cable to the location
(i.e. under the seat or in the panel).
A/V Control Module Installation
1. Locate suitable A/V Control Module mounting location
(i.e. center console).
2. Attach the A/V Control Module wires as follows:
Wire Color Connection
1. Red +12V Battery
2. Orange +12V Reverse Light
3. Black Ground
3. Secure the A/V Control Module using the provided screws.
Package Contents & System Diagram
• 3.5˝ LCD Monitor w/Mirror Mode Display
• Color CCD Bullet-Type Camera w/Cable
• Angled Controller Rings (3 sizes)
• Fixing Rings
• A/V Control Module
• Monitor Cable
Camera Installation
1. Locate a suitable camera mounting location on the Car Body
(i.e. center of the rear bumper). (Fig. 1)
2. Drill a 1-
1
⁄8˝ diameter hole at that location.
3. Attach the desired Angled Controller Ring to the Camera
Body before installing.
4. Insert the Camera Body through the car body and attach the match-
ing Angle Controller Ring and spacer to the Camera Body.
5. Secure the Fixing Rings to the threaded portion of the Camera Body
locking the camera in place.
A/V Control
Module
LCD
Monitor
+12V
Battery
Ground
+12V
Reverse light
CCD
Camera
Fig. 1
Fig. 2
/
