GE JXS81WW Installation guide

Type
Installation guide

This manual is also suitable for

1
TOOLS YOU WILL NEED
Safety Glasses
Cut Resistant Gloves
“If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com”
PARTS INCLUDED
(3) ¼” drive #8 x 3/4”
Sheet Metal Screws
T10 TORX
®
Bit
Island Trim
31-10953 02-14 GE
Installation
Instructions
Gas Slide-in Range
Island Installation Kit
In order to install the island trim kit, you must first
remove the two (2) short trim pieces on both sides.
1. Remove (3) three T10 TORX
®
screws.
2. Remove (1) one ¼” sheet metal screw retaining
the rear trim and discard.
NOTE: When the screws are removed from the
rear trim it may flex away from the back of the
range – this is normal.
3. Remove short trim.
4. Repeat steps 1 thru 3 on the opposite corner.
Nutdriver
Side Trim
Short Trim
Rear Trim
Sheet Metal
Screw
T10 TORX
®
Screws
2
Installation Instructions
5. Install island trim piece making sure that the
side lap joint engages with the side trim on
both sides.
NOTE: Make sure that the notch on island trim
fits into the slot of the rear trim.
6. Install the (2) two ¼” sheet metal screw provided
in the kit thru the corner trim and rear trim.
NOTE: This will draw the corner trim and rear
trim together.
7.
Install (2) two T10 TORX
®
screws into the side trim.
8.
Install (1) one T10 TORX
®
screws into the island
trim.
9.
Repeat steps 7 & 8 on the opposite corner.
NOTE: Island trim will protrude approximately
1/2” beyond the rear of the rear trim.
10. Install (1) one ¼” sheet metal screw provided in
the kit thru the center hole of the island trim.
11. Install the range per the range installation
instructions.
¼” Sheet
Metal Screws
Side Trim
T10 TORX
®
screws
Island Trim
T10 TORX
®
screws
¼” Sheet
Metal Screw
Island Trim
  • Page 1 1
  • Page 2 2

GE JXS81WW Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI