Viking PDDP242SS Installation guide

Type
Installation guide
Installation Guide
Dishwasher Door Panel Kits
PDDP242 / RVDP324/TVDDP24
2
Door Panel Installation
For FDW300/FDW300WS/FDW100/FDW100WS/FDW101 and
FDW101W Models (Purchased Separately)
C
D
C
D
The unit comes with everything needed to make installing the door panel easy.
What you will need:
Phillips Head #8 1-3/4” long, Stainless Steel
Screwdriver Phillips Head Screw
(4 supplied)
Dishwasher Door
Plastic
Retainers
Door Panel
3
Installation
1
Plastic
Retainers
2
3
x2
D
D
D
C
C
4
x4
D
D
Remove plastic retainers from door panel
and discard.
Remove plastic mounting brackets from
the dishwasher and discard.
Carefully open the dishwasher door.
Remove the (2) white caps from holes (C)
and the (2) top screws from holes (D) on
dishwasher door.
Carefully secure the door panel to the
dishwasher through holes (D) using the four
at PHD screws provided. Carefully tighten
all four screws and check to ensure that the
panel is square with the dishwasher door.
Do not over tighten screws. This may
cause damage to the inner door.
Note: Verify the operation of the door counterbalance springs after installation of the door skin.
Note: Verify that the door does not hit the kickplate. Adjust kickplate if necessary.
4
Door Panel Installation
For FDB451 Models (Purchased Separately)
The unit comes with everything needed to make installing the door panel easy.
What you will need:
Torx Driver #8 1-3/4” long, Stainless Steel
Truss Head Screw
(4 supplied)
C
D
D
C
D
D
Dishwasher Door
Plastic
Retainers
Door Panel
5
Installation
1
C
Plastic
Retainers
2
x4
D
D
D
3
x4
D
D
Position door panel on front of dishwasher
door. Snap the plastic retainers on the door
panel into the holes (C) on dishwasher door.
While holding the door panel in position,
carefully open the dishwasher door.
Using the four truss head screws provided,
secure the door panel to the four holes (D)
on the dishwasher door
Carefully tighten all four screws and check
to ensure that the panel is square with the
dishwasher door.
WARNING
The door skin must not obstruct the
fan exhaust vent.
Note: Verify the operation of the door counterbalance springs after installation of the door panel
6
7
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-845-4641
or visit the our web site at vikingrange.com in the US
or brigade.ca in Canada
F21018D (051515)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Viking PDDP242SS Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI