KOGAN TV STAND MOUNT
WITH SHELF
(SUITABLE FOR 37” – 70” TVS)
KASTDGLSBLA
Read the entire instruction manual before you start installation and assembly. If you have
any questions regarding any of the instructions or warnings, contact your local distributor for
assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in
instability causing possible injury.
• Please closely follow the assembly instructions. Improper installation may result in
damage or serious personal injury.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep
these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
• Never exceed the maximum load capacities of 40kg (for the mount) and 5kg (for the
shelf) or it may result in product failure or personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist
prior to installation. If any parts are missing or faulty, contact your place of purchase for a
replacement.
MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at
least every three months).
SAFETY & WARNINGS
A Base (x1) B Lower stand (x1) C Upper stand (x1)
D Shelf (x1) E Wall plate (x1) F Brackets (x2) G Fastener (x2)
H Feet (x6) I (x3) J (x4) K (x3) L (x7) M (x4) N (x2) O (x1)
M-A M5x14 (x4) M-B M6x14 (x4) M-C M6x30 (x4)
M-D M8x30 (x4) M-E M8x50 (x4)
M-F (x4) M-G (x8) M-H (x8)
Required for installation (not supplied)
Phillips head
screwdriver
COMPONENTS
Step 1
Attach feet (H) to bottom of base (A).
Step 2
Using the Allen key (O), secure the lower stand (B) to the base (A) using x3 I screws, along
with x3 K and L washers.
MOUNT ASSEMBLY
Step 3
Insert upper stand (C) into the lower stand (B) and secure with the x4 J screws.
Step 4
Attach the wall plate (E) to the upper stand (C) using the M screws and remaining x4 L
washers.
Step 5
Attach the shelf (D) to the lower stand, first by inserting the tab of the shelf into the opening
in the lower stand (refer to figure 1 below), then securing with x2 N screws (figure 2). Use a
Phillips head screwdriver (not supplied) to secure the screws.
Align the bracket with your TV’s VESA holes and secure using supplied screws and square
spacers (M-F) depending on required length. Use a Phillips head screwdriver (not supplied) to
secure the screws.
Check if additional spacers (M-G, M-H) are required to ensure correct length of screw, as per
the below image. Failure to follow this step may result in damage to your TV or wall mount.
INSTALLING BRACKET TO TV
Hook the TV with brackets installed onto the wall mount at the desired height. Two people
should carry the TV to prevent damage.
Once in place, attach and tighten the fasteners (G) using a Phillips head screwdriver.
SECURING TV TO MOUNT
Use the openings in the stand assembly for cable management.
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
/
