STEP 1: Thoroughly clean the entire glass surface
with the cleaner supplied in cleaner wipe. Remove all
traces of adhesive residue from any previously applied
screen protector.
STEP 2: Allow device to fully dry.
STEP 3: Ensure you remove all traces of the cleaner by
buffing the glass thoroughly with the microfiber towel
supplied.
Any adhesive residue or cleaner trace left on the glass
surface will adversely affect the ability of SureShield™ to
bond to the glass.
INSTALLATION INSTRUCTIONS
2. Apply the nano coating
STEP 1: In a circular motion, apply the SureShield™ nano
coating to all glass surfaces using the coating wipe
supplied in nano coating wipe. Make sure screen is
completely coated including edges.
STEP 2: Allow glass surface to dry for at least 10
minutes. When dry, a residue will be visible on the glass.
STEP 3: Once fully dry, remove any excess residue with
the microfiber towel supplied.
Following the application of nano coating, you may
notice that some minor scratching appears on your
device. Please do not be concerned as this scratching
is in a layer of excess liquid glass remaining on your
screen after application. This scratching is easily
buffed off using the microfiber towel supplied. Your
device screen remains protected by the nano coating
cover case at all times.
3. Post application
For optimal results, apply SureShield™ to your mobile device last thing
at night to allow maximum drying and bonding time.
1. Pre-cleaning device screen
PRODUCT WARNING:
Keep out of reach of children and sources of ignition. In case
of contact with eyes, rinse immediately with clean water and
seek medical advice.
SURESHIELD™
