User’s Manual – AREBOS Juice Extractor 800W
6
4. Service
- Make sure that the appliance is serviced only by specialist personnel, and that only original spare
parts or accessories are used to replace existing parts/accessories.
- Any misuse or failure to follow the instructions for use renders the guarantee and the
manufacturer’s liability null and void.
5. Instructions for use
5.1 Before use
- Make sure that all the product’s packaging has been removed.
- Before using the product for the first time, clean the parts that will come into contact with food in
the manner described in the cleaning section.
5.2 Use
- Unroll the cable completely before plugging it in.
- Make sure the filter (C) is well placed, turning and pressing down.
- Place the protective lid (B) in the correct position.
• Connect the appliance to the mains.
• Place the deposits of juice (F) and pulp (G) in the position.
• Once you have checked that the closing clamps (E) are well fitted.
• -Turn the appliance on, using the speed selector (I).
• -Note: If the all the parts are not correctly assembled, the appliance will not start.
• The illuminated ring (J) will be lighted.
• Choose desired speed: I (low speed) or II (normal speed).
• -Speed I is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers…
• -Speed II is suitable for all other kinds of fruits and vegetables such as apples, carrots…
• Insert the properly-cut fruit or vegetables into the corresponding opening in the protective
lid
• Squeeze it gently with the pusher.
• The juice and the residual pulp will automatically separate out: the juice into the glass (F) and
the residual pulp into the pulp collector (G).
• Do not exert too much pressure on the pusher as it could affect the quality of the end result.
It could even cause the filter come to a halt.
• Do not use the appliance for more than 3 minutes at any one time. Stop the motor and allow
it to cool for at least 2 minutes. Otherwise the motor may become damaged.
• Once finished, leave the motor to run a few seconds so that the juice can be strained.
• Stop the appliance, selecting position 0 on the selector control. (I)
• Before opening the blender, ensure that the motor has stopped completely.
• Open the two closing clamps (E).
• Remove the deposits of juice (F) and pulp (G), the pusher (A) and the protective lid.
• First pull the filter (C) and then the upper body (D).
• Remark: If you process a large quantity of fruit, you must periodically clean the filter and
remove the remains of the pulp.
