DuraScan 600 Series

Socket Mobile DuraScan 600 Series User manual

Hello! I've reviewed the battery replacement instructions and am ready to assist with your questions. The document provides clear steps for replacing the battery, including how to remove the battery door, disconnect the old battery, connect the new one, and proper charging guidelines. I'm ready for your questions.
What tool is needed to remove the battery door?

How do you remove the battery?

What are the charging requirements?

B R

I

Step 1 Remove Btter Door

Use screw driver to loosen screw and remove battery door.

Step 2 Remove Btter

Use a flat head screw driver and place in the top right

corner to gently push the battery out. Then, pull the

connector to remove.

Step 3 Insert New Btter

Plug the connector on the new battery.

Step 4 Secure Btter Door

Ensure the battery door is properly placed, then screw the

battery door back on.

Step 5 Use  wll chrer to chre btter untl the

btter lht turns sold reen (up to 8 hours)

Chrn Requrements Min 5.0 VDC, 1 AMP

Max 5.5 VDC, 3 AMPs

04/2022 6430-00407B

/

Other documents