Power Probe PPTACT1CS Operating instructions

!The!Probe!Instructions!!

Connect!alligator!clip!to!positive!or!negative!source!on!vehicle.!When!testing!for!voltage!or!ground.!Switch!

must!be!pressed.!When!bulb!illuminates,!voltage!is!present.!If!voltage!is!greater!than!12.0v,!the!bulb!will!

illuminate!and!tool!will!vibrate.!On!a!good!ground,!the!bulb!will!illuminate!green.!On!a!bad!ground,!or!a!

resistance!of!10!to!600!Ohms,!the!Tool!will!illuminate!Blue.!!

Installing!/!Replacing!Battery!!

1.!Unscrew!end!cap!of!tool!!

2.!With!your!hand!holding!the!tool,!slide!switch!back!and!gain!access!to!circuit!board!!

3.!Install!battery!with!negative!(-)!side!facing!the!circuit!board.!!

4.!Re-install!switch!and!screw!end!cap!of!tool.!!