X-PLOR X-PLOR Dust Cap Cartridge User guide

X-PLOR Dust Cap Cartridge
Brand
X-PLOR
Model
X-PLOR Dust Cap Cartridge
Type
User guide

This manual is also suitable for

Removing Cartridge.
Cartridge Replacement
STEP 1
Turn o the X-PLO₂R® by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLO₂R.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLO₂R
from the carrying bag,
if applicable.
Place the X-PLO₂R on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLO₂R
and throw away.
Turn sheet over to continue to step 2. LBL 5026-01
1
1
3
3
5
5
2
2
4
4
6
6
By:
Dust Cap
Installing Cartridge.
Cartridge Replacement
STEP 2
XplorOxygen.com
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLO₂R so it is fully inside.
Connect charged battery
to the X-PLO₂R.
Insert new cartridge top first into the
X-PLO₂R. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLO₂R as soon as
the used cartridge is removed.
The cartridge pull handle
should lay flat once the cartridge
is secured.
Turn on the X-PLO₂R by pressing the
power button for 2 seconds. Set the
flow setting to your prescribed setting
and use normally.
1
1
3
3
2
2
4
4
6
6
5
5
LBL 5026-01
By:
  • Page 1 1
  • Page 2 2

X-PLOR X-PLOR Dust Cap Cartridge User guide

X-PLOR Dust Cap Cartridge
Brand
X-PLOR
Model
X-PLOR Dust Cap Cartridge
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents