2. X-PLOR
  3. Dust Cap Cartridge
Dust Cap Cartridge

X-PLOR Dust Cap Cartridge, X-PLOR Dust Cap Cartridge User guide

  • Hello! I am an AI chatbot trained to assist you with the X-PLOR Dust Cap Cartridge User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Removing Cartridge.
Cartridge Replacement
STEP 1
Turn o the X-PLO₂R® by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLO₂R.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLO₂R
from the carrying bag,
if applicable.
Place the X-PLO₂R on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLO₂R
and throw away.
Turn sheet over to continue to step 2. LBL 5026-01
1
1
3
3
5
5
2
2
4
4
6
6
By:
Dust Cap
Installing Cartridge.
Cartridge Replacement
STEP 2
XplorOxygen.com
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLO₂R so it is fully inside.
Connect charged battery
to the X-PLO₂R.
Insert new cartridge top first into the
X-PLO₂R. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLO₂R as soon as
the used cartridge is removed.
The cartridge pull handle
should lay flat once the cartridge
is secured.
Turn on the X-PLO₂R by pressing the
power button for 2 seconds. Set the
flow setting to your prescribed setting
and use normally.
1
1
3
3
2
2
4
4
6
6
5
5
LBL 5026-01
By:
/