Raven RTH-10 User manual

Category
Motorcycle Accessories
Type
User manual
3. Battery Performance
The battery is fully recharged after
8-12 hour with applied power
The solar panel supports a continuous
charge with a few hours of sunlight
per day*
*May vary dependent on the users
geographic location
1. Getting Started
The Solar Hybrid device is IP67
rated, can be mounted exteriorly
or interiorly. The magnetic mount
allows it to be mounted without
hardware on magnetic surfaces.
2. Wired & Non-Wired
Installation
Wired Installation (Recommended)
Device will report every
30 seconds when moving
Red Wire — 12V Power
Black Wire — Chassis Ground
Yellow Wire — Not Used
Non-Wired Installation
Device will report every 5 minutes
when moving
MORE
RTH-10 Device Installation
Solar Hybrid Device
Open Wires
*Magnetic Cradle Included
Device
Plug
Hours | 7 AM5 PM CST | MonFri
Sales & Support | (800) 243-5435
Login | tracking.ravenslingshot.com
Website | ravenprecision.com
6. Verify Device Installation
When the Solar Hybrid device has
power, a red light will be solid
Single Blue LED Cellular service
Single Red LED GPS service
5. Device Installation
Align the device plug and insert it into
the Solar Hybrid device
when the wire harness in firmly in
place, screw the collar down firmly
Do not push the attachment in at an
angle or use too much force
7. Look — You’re On The Map!
Log-in to tracking.ravenslingshot.com
or open your app and start tracking!
Questions & Troubleshooting
Call +1 (800) 243-5435 to talk to a
Technical Support Specialist or
visit edge.ravenprecision.com and
view the Slingshot on Demand
training resources.
4. Wire Management
Run the device plug to the preferred
storage location
Secure the cables to ensure safe
asset and device operation
  • Page 1 1
  • Page 2 2

Raven RTH-10 User manual

Category
Motorcycle Accessories
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI