Adjusting display backlighting/contrast
Normal operation
ST40 Speed Instrument - quick reference guide
orTo exit adjust mode press or wait for 5 second timeout
LEVEL 1
LEVEL 1
OFF LEVEL 2LEVEL 3LEVEL 2
To enter adjust mode, press for 1 second to adjust BACKLIGHTING and a further 1 second to adjust CONTRAST
SWITCH ON
Last permanent screen is displayed
Current
speed
3 seconds
Reset
Maximum
speed
Average
speed
Water
Temp.
Log
Trip
Note:
*
denotes temporary screens which will
time-out to the previous permanent
screen after 5 seconds.
3 seconds
Reset
3 seconds
Reset
86046_2.p65 18/04/01, 16:031
Calibration
ST40 Speed Instrument - quick reference guide
Document number: 86046_2 (to be used with handbook: 81157_2)
Date: 1 May 2001
USER CALIBRATION
for 2 seconds
Hold down
and
User
cal
Set to
SOG
Speed
response
Cal
factor
INTERMEDIATE CALIBRATION
Software
version
Hold down
and
for 4 seconds
Instrument
status
Speed
units
KTS
MPH
KPH
Temp.
units
To leave any calibration routine and return to normal operation,
for approximately 2 seconds
+
-
+
-
F
C
andhold down
Note:
In User calibration only the Entry and
Speed response screens are availble
on repeater instruments.
Distance
units
SM
KM
NM
Press for 3 seconds
to apply SOG as
current speed
MASTER
REPEATER
If there is no key activity with either
the User cal or Software version
screen displayed, calibration will time
out to normal operation after 5 seconds
86046_2.p65 18/04/01, 16:032
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Raymarine Boating Equipment FE1A10GR User manual
-
-
-
-
-
-
-
-
-