Thermos 461742204 Owner's manual

Category
Barbecues & grills
Type
Owner's manual
Note: Grill lid
style may vary.
Qty: 2
461742204
Items to Assemble:
2 Wheel Assemblies
2 Hitch Pins
2 Leg Extenders
Items to Assemble:
2 Leg Assemblies
1 Bottom Shelf
6 Carriage Bolts
6 Wing Nuts
Qty: 6
Qty: 6
Place Bottom Shelf and Legs as shown.
After assembling tighten all Wing Nuts.
Right Side:
Attach 2 Carriage Bolts and Wing Nuts in
front and back.
Left Side:
Place 1 Carriage Bolt
and Wing Nut in upper hole only
Items to Assemble:
1 Grill Bottom
1 Heat Shield
2 Carriage Bolts
2 Wing Nuts
2 Control Knobs
Items to Assemble:
1 Right Shelf
4 Wing Screws
Qty: 4
Items to Assemble:
2 End Caps
1 Toolholder
1Carriage Bolt
1 Wing Nut
Place Carriage Bolt in right hole on Toolholder. Secure with Wing Nut.
Items to Assemble:
1 Sideburner Body
1 Sideburner Frame
1 Carriage Bolt
1 Wing Nut
1 Crown Screw or Wing Nut
Join Sideburner Body and Frame. In back center hole attach with Carriage Bolt and Wing Nut.
In front use a Crown Screw or Wing Nut to attach Toolholder and Sideburner Body.
A
Items to Assemble:
1 Sideburner
1 Wing Nut
1 Sideburner Valve Cup
1 Sideburner Knob
1 Sideburner Grate
A
B
C
Place Sideburner into hole.
Attach Sideburner Valve Cup. Make sure
Sideburner Tube is inside of valve. Tighten
with Wing Nut.
Place Sideburner Knob and Grate
Correctly assembled Sideburner Tube in Valve
B
C
Attach long wire from beneath console
to electrode beneath Sideburner.
D
D
Item to Assemble:
1 Wire Shelf
1 Panel
2 Push Pins
Qty: 2
Assemble front panel first by
placing tabs into slots on Bottom Shelf.
Attach with push pins.
A Place Wire Shelf in 3rd hole from top.
B
A
B
Items to Assemble:
1 Lower Warming Rack
1 Upper Warming Rack
1 Grate
A
B
C
Insert pivot wire of Lower Warming Rack into Lid.
Flex leg wires to insert into Grill bottom.
Insert pivot wire of Upper Warming Rack into lid.
Flex leg wires to insert into loops on Lower Rack.
Place grate.
Leg wires on both Warming Racks
must run underneath surfaces.
Legs snap into loop
B
A
Qty: 1
Qty: 1
Qty. 2
Qty.2
Attach Wheels with Hitch Pins
Qty: 1
Qty: 1
Qty: 1
Qty: 1
or
Items to Assemble:
1 V-Bar
Push V-Bar down onto
rest in Grill Bottom
Hinge Pin
and Hitch Pin
Qty: 2
Qty: 2
Qty:2
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
1 Temp Gauge Bezel
1 Temperature Gauge
w/Wing Nut
C
Grate
See Use & Care Manual for “Match Lighting Instructions” and to
perform the Burner Flame Check” and important safety
instructions before using.
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang
from grease clip.
Back of Grill
Items to Assemble:
1 Grease Clip
1 Tank Wire Support Bracket
LP tank is sold separately. Use only with an
(over-fill protection device) OPD equipped LP Tank.
Fill and leak check before attaching to grill and regulator.
CAUTION
!
Failure to install can in clip will cause hot grease
to drip from bottom of grill with risk of fire or
property damage.
Tank collar opening must face to front of cart
once tank is attached.
Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
Qty: 1
1
9
12
11
10
9
8
4
5
6
7
1
2
3
  • Page 1 1

Thermos 461742204 Owner's manual

Category
Barbecues & grills
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI