ICP CAN-2084C is a CANopen Slave module with 8 isolated/non-isolated digital inputs and is used to connect sensors and actuators to a CANopen network. The module has 10 Rx and 10 Tx PDOs, which support event triggered, remotely requested, cyclic, and acyclic SYNC PDO modes. The baud rate can be set between 10k and 1M bps using a rotary switch, and the node ID can be set between 0 and 99 using the same switch. The module has a built-in error control mechanism and supports the Node Guarding protocol and Heartbeat Producer protocol.
ICP CAN-2084C is a CANopen Slave module with 8 isolated/non-isolated digital inputs and is used to connect sensors and actuators to a CANopen network. The module has 10 Rx and 10 Tx PDOs, which support event triggered, remotely requested, cyclic, and acyclic SYNC PDO modes. The baud rate can be set between 10k and 1M bps using a rotary switch, and the node ID can be set between 0 and 99 using the same switch. The module has a built-in error control mechanism and supports the Node Guarding protocol and Heartbeat Producer protocol.
ICP CAN-2084C is a CANopen Slave module with 8 isolated/non-isolated digital inputs and is used to connect sensors and actuators to a CANopen network. The module has 10 Rx and 10 Tx PDOs, which support event triggered, remotely requested, cyclic, and acyclic SYNC PDO modes. The baud rate can be set between 10k and 1M bps using a rotary switch, and the node ID can be set between 0 and 99 using the same switch. The module has a built-in error control mechanism and supports the Node Guarding protocol and Heartbeat Producer protocol.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI