iTronics IT-01 User manual

Type
User manual
Ultrasonic Aroma Diffuser
User Manual
Model No.: IT-01
V20171019 EN FR
Operating Instructions Mode d‘emploi Page 4 Page 11
-2- -3-
3H 4H
1H 2H
3H 4H
1H 2H
3H 4H
1H 2H
3H 4H
1H 2H
8
6
1
5
3H 4H
1H 2H
2-3
3
3H 4H
1H2H
3H 4H
1H 2H
7
3H 4H
1H 2H
2
120ml
4
3H 4H
1H 2H
Important instructions
These operating instructions contain important information for proper and safe
operation of the product.
Therefore, read the operating instructions through in full before you use the
product. Otherwise there is a risk of hazards to personnel and damage to the
product.
Keep the operating instructions safe. If you pass on the product to third parties,
you must also hand over the operating instructions with it.
Intended use
The product is used for producing aroma in to the air in closed indoor rooms only.
The product is not intended for commercial use but rather only domestic use.
Intended use also includes compliance with all information and spec-ifications
contained in these operating instructions. Any use other than for its intended
purpose shall be deemed as misuse.
Misuse
Misuse of the product can lead to hazardous situations.
Only ever fill the product with water. Do not use any other liquids.
Do not use the product in wet rooms, such as bathrooms or sau-nas.
Do not use the product in rooms with open fire (fireplace, gas cooker, candles
etc.).
General Notes
Do not insert any objects into the openings of the product.
Do not place the product directly in front of an air conditioning unit or other
electrical devices.
The device must be used only with the adapter supplied with the appliance.
Children
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.
Make sure that the product is set up out of the reach of children.
Make sure that children are not allowed to play with the product at any time.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not leave packaging material lying around unattended. There is a risk
of asphyxiation.
Improper handling
Improper handling of the product can cause injuries.
Make sure that the product is connected properly. In the process, adhere
to these operating instructions.
Make sure that the product is used properly. Never cover it.
Be aware that unauthorised conversion and/or modification of the product
is prohibited. In case of unauthorised conversion and/or modification the
warranty cover will be rendered null and void.
Never open the water tank during operation.
Only empty the water tank on the drain side. It is marked "Drain Side" on
the product.
Before filling or emptying the product, always pull the mains plug from the
socket.
Before installation, cleaning or a period in which the product is not used,
pull the mains from the socket.
Empty the water tank before a period in which the product is not used.
Contact the manufacturer or a specialist if you have any doubts regarding
the way the product works, its safety or how to connect the product.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Setup
If liquids, damp air or fire come into contact with the product, there is a risk
of injuries.
Do not set up the product in rooms with high air humidity, such as bathrooms
or saunas.
Make sure that no liquids enter into the inside of the housing. This will not
only destroy the product but there is also a risk of fire.
-4- -5-
EN EN
-6- -7-
EN EN
Protect the product from the effects of the elements. Do not set it up outdoors.
Only ever place the product on flat surfaces. If placed on an inclined surface,
water from the water tank may enter into the housing.
Make sure that the air inlet openings on the base of the product are knot
covered or sealed.
Aroma Diffuser Features
Mist
Press button.
* Press once: turns green indicator on, which is intermittent mist (mist every
30 seconds and pauses for 30 seconds).
* Press again: turns to blue indicator, and changes to continuous mist model.
* Press third time: power off.
Timer
1. First, choose your mist type between continuous mist (blue) or intermittent
mist (green) mode. Then press the Timer button repeatedly to set the desired
runtime.
2. The timer options are:
* Press once: 1-hour count down timer is set and corresponding LED(1H) will light
up.
* Press again: 2-hour count down timer is set and corresponding LED will
light up.
(2H)
* Press third time: 3-hour count down timer is set and corresponding LED
will light up.
(3H)
* Press fourth time: 4-hour count down timer is set and corresponding LED
will light up.
(4H)
* Press fifth time: turns count down timer off.
You can also turn on the timer by pressing the timer button first. By doing this,
the mist will only disperse in continuous mode. If you wish to set intermittent
mist mode, you must do so by pressing the mist button first and selecting
intermittent mist mode.
Note: Light and Timer function can be used at the same time.
Operation
Other Function
Anti-dry system: When there is no water or a little amount of water in the water
tank, the power supply will automatically and immediately turn off even with
power connected except for the light function, and the device will beep 6 times
as a warning.
1. Remove top cover (dia. 1).
2. Fill with distilled water to the maximum mark (120 ml) (dia. 2)
3. Add 2-3 drops fragrance oil (dia. 3).
4. Replace top cover while ensuring perfect fit (dia. 5).
5. Connect power supply unit (dia.6).
6. Place on a level surface (dia.7).
7. Switch on: Press “ ” button (dia.8).
The aroma diffuser is a modern fragrance diffuser which uses ultrasound
technology to generate a fine mist and thus distribute the fragrance
throughout the whole room. The aroma diffuser has the following functions:
NOTE: The top cover of the device consists of an inner cover and outer cover. The
inner and outer cover have been assembled together at our manufacturing facility
but it's possible, the inner cover has detached from the outer cover. If so, please
insert the inner cover back into the outer cover firmly (dia. 4 )before you place the
top half of the device back on the diffuser base. Otherwise, the diffuser will not
operate as intended.
LED Light
*
* Press again to stay on the current color.
* Press the LIGHT button repeatedly to select the desired color.
* Press and hold the LIGHT button for 3 seconds to turn off the light.
Note: Light and mist function can be used at the same time.
Press the LIGHT button once to automatically cycle through the different colors.
-8- -9-
ENEN
3H 4H
1H 2H
In the event of the unit being knocked over or tipped during use, please follow
the steps below to avoid malfunction.
Unplug the unit and remove cover.
Pour any remaining water out of the water tank.
Shake the unit gently to drain any water inside the mechanism, and then
allow drying for at least 24 hours.
Accidental Leakage
3H 4H
1H 2H
3H4H
1H 2H
3H4H
1H2H
Troubleshooting
Experiencing issues with your device? Please check below troubleshooting
tips before contacting us if you wonder whether damage occurred.
SYMPTOM
Unit is not
powering on
No mist or
abnormal mist
Water leakage
from product
POSSIBLE CAUSE
Is there any water in the water
tank?
Is there enough water in the
water tank?
Is the power cord connected
properly?
Not enough water?
Too much water ?
Dirt on the ultrasonic plate?
Cover and inner cover are not
installed properly?
Dirt on the air suction port
at the base?
Cover and inner cover are not
installed properly?
Has the inner cover shifted?
Low temperature or high
humidity?
SOLUTION
Add water to tank.
When there is no water or a little amount
of water in the water tank, the power
supply will automatically and immediately
turn off after pressing the MIST button.
Disconnect the adapter, check cables
and re-connect carefully.
Add water to tank.
When the water reaches above the max,
the mist will be abnormal.
Clean the water tank. (Please refer to
the Maintenance Section)
Fix the cover and inner cover because
the mist cannot reach to the FOG
NOZZLE without right installation.
If there is dirt on the air suction port,
the airflow will be restricted and then
mist cannot be blown out.
Fix the cover and inner cover.
The produced mist cannot reach to FOG
NOZZLE and will cause water droplets if
the cover and inner cover shifted.
Under these conditions, the mist may
condense quickly into water droplets.
Electrical and electronic components must not be disposed of
with the domestic waste. Once the product reaches the end of
its service life, dispose of it and its components separately in
accordance with the local valid regulations for disposal.
Disposal
Wipe with a soft cloth. Avoid Ultrasonic Vibration plate area, Which can
be gently cleaned with a cotton bud.
Pour out any remaining water from the DRAIN SIDE” of the tank.
Unplug power cord from the base of unit. the
Put 1 tablespoon of citric acid in the water tank, add just under 120 ml of
warm water.
Leave for 5 minutes, and then drain solution from the “DRAIN SIDEof the tank.
Unplug the unit from mains power supply and remove cover.
After using 5-6 times, or 2 3 days, please clean the product as follows.-
Maintenance
-10-
EN
Dimensions
Weight(Excluding Adapter)
Tank Capacity
Mist Amount
Power Input/Output
Applied Area
Rated Power
Specifications
Limited one-year warranty
iTronics warrants this product to be free of defects in parts, materials and
workmanship for a period of one year, from date of purchase.
Should any repairs or servicing under this warranty be required, contact
Customer Service by phone or email for instructions on how to pack and ship
the product to iTronics.
Customer service
Telephone: 1-877-515-7797(USA & Canada only)
Email: service@myitronics.com
Hours: Weekdays 8:00 AM- 6:00 PM EST
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
We reserve the right to make technical and design changes in the interest
of constant product improvements.
138*138*130 mm
450 g
120 ml
20-40 ml/hr
AC100-240V 50/60HZ/ DC 24V 500mA
20-30
11 W
Frequency 2.4HZ
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

iTronics IT-01 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI