LAMONA LAM2376 Operating instructions

LAM2375 & LAM2376

Addendum For Recirculation Mode

Please note: This addendum applies for

recirculation use only

The 2 part v-ﬂap should always be ﬁtted to

stop anything dropping into the motor

The current installation guide (on page 10),

indicates a square hole should be cut in the

top of the cabinet. This is not the case in

this recirculation application.

Carbon Filter

The carbon ﬁlter needed for this product is LAM2004.

Please make a note of this in the instruction booklet provided with the product for

future reference.

Note: If using in externally ducted mode, then please follow the instruction booklet.

2 part v-ﬂap

Cable grid to be ﬁtted over

the hole

Follow the diagram below for cutting the cabinet to ﬁt the cable grid.

This hole should be 130mm in diameter.

130mm

This manual is also suitable for