Assembly Instructions: GAEH-BA3

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Remove all of the contents from the carton. See the important

notes above. Shut off the power at the circuit breaker and

completelyremovetheoldxturefromthewall,includingtheold

wiresthroughthecenterofmountingstrap(B).Placemounting

strap(B)overthejunctionboxsothatmountingscrews(A)are

horizontal,andinalignmentwiththeholelocationsonthexture

backplate(F).Securemountingstrap(B)tothejunctionbox

withmountingscrews(D)andascrewdriver.Tightenthescrews

securely.

CONNECTING THE WIRES

Attachthexture’swirestothepowersupplywiresfromthe

junctionbox.Connectblacktoblack(orsmooth);whitetowhite

(orribbed);groundtoground(greenorcopper).Twisttheends

surealltwistsareinthesamedirection.Ifthereisnogroundwire

(greenorcopper)fromthejunctionbox,locategroundscrew(E)

onmountingstrap(B)andwrapthexturegroundwirearound

thegreengroundscrew(E).Useascrewdrivertosecureground

FINISHING THE INSTALLATION

Slideglassshades(I)oversockets(H)andsecureinplacewith

Installthebulbs(notincluded)inaccordancewiththexture’s

specications.Donotexceedtherecommendedwattage.

Your installation is now complete. Turn on the power and test the

xture.

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

For Customer Service, contact