6011
CATALOG NUMBER
Description
The FM-200TM System Flexible Discharge Hoses are used to
facilitate connections between cylinder valves and system
manifold or piping. They minimize the effects of variations in
the height of cylinder valve outlets due to dimension
tolerances necessary in cylinder manufacture, and due to
floor irregularities.
Flexible Discharge Hoses are provided in 1½, 2 and 2½
inch sizes.
All flexible discharge hoses are Unified Thread (flare type)
on the valve end and Male NPT on the system side. A Valve
Outlet Adapter must be used to connect to system piping if
a flexible discharge hose is not used.
Architect Specifications
The Flexible Discharge Hoses shall be of the same pipe size
as the cylinder valves which they serve. They shall be wire-
reinforced, have a minimum working pressure of 560 psi,
and a minimum burst pressure of 2,250 psi. They shall be
marked with the Cerberus Pyrotronics part number and
shall be UL listed and FM approved.
Ordering Information
Part No. Description
Lbs. Kg.
500-283898
500-283899
500-283900
1 ½" comes 24 inches
2" comes 31 inches
2 ½" comes 48 inches
4.4
6.0
14.6
2.0
2.72
6.62
FM-200TM Extinguishing Systems
Flexible Discharge Hose
ENGINEER AND ARCHITECT SPECIFICATIONS
Features
•Enhances Cylinder to Pipe
Connections
•Wire Braid Reinforced
•Low Restriction to Flow
• Listed, Pending
•FM Approved, Pending