2. SMITH SYSTEM
  3. 179802

SMITH SYSTEM 179802 Assembly Instructions

  • I've reviewed the provided Quick Installation Guide for the SMITHSYSTEM Planner Lab models. The document outlines the steps for assembling the table, including attaching the legs, back panel and adjusting height using specific tools and fasteners. I'm ready to answer any questions you have about the assembly process.
  • What should I do before starting the assembly?
    How are the legs initially attached to the table top?
    How is the back panel attached to the legs?
    When should I tighten the leg screws?
    What tool is used to adjust the height of the legs?
Instructions
Step 1 Place table top on a smooth, clean
surface with bottom facing up.
Step 2 Align the legs to the pilot holes on
The table top and use (12) #10
wood screws to loosely attach
theLegs to top.
Step 3 Attach the back panel to the legs
using the (4) connector bolts and
allen wrench Provided.
Step 4 Now go back to Step 2 and tighten
the screws To secure the legs to the
table top. Using the extended
Drill bit secure the back panel to the
top. DO NOT OVER TORQUE SCREWS!
Step 5 Once the legs are securely attached
adjust the legs to the desired height
using the allen wrench provided.
Planner Lab Quick Installation Guide
model 24610, 24500, 24510, 24520, 24620, 24530, 24630, 24540, 24550, 24560, 24570
#10 Wood Screws Back Panel (1)
3/8” - 16 Dog Nut Screw (4)
Legs (2)
Allen Wrench (2)
Connector Bolt (4) Table Top (1)
Drill Extension (1)
Form# 179802 Rev. 8/2006
/