Wel-Bilt Please see replacement item# 37805. 500 Amp Battery/Carbon Pile Tester Owner's manual

Brand
Wel-Bilt
Model
Please see replacement item# 37805. 500 Amp Battery/Carbon Pile Tester
Type
Owner's manual
500 AMP
CARBON PILE LOAD TESTER
OWNER’S MANUAL
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and other
basic safety precautions may result in serious personal injury.
Item# 1673861
Page of 4
2
Thank you very much for choosing a Wel-Bilt™ product! For future reference, please complete
the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This machine is designed for certain applications only. The distributor cannot be responsible for
issues arising from modification. We strongly recommend this machine not be modified and/or
used for any application other than that for which it was designed. If you have any questions
relative to a particular application, DO NOT use the machine until you have first contacted the
distributor to determine if it can or should be performed on the product.
For technical questions please call 1-800-222-5381.
FEATURES:
• Tests 12V batteries, alternators, regulators and starters
• Tests batteries up to 160Ah/1000CCA
• 500 Amp adjustable load carbon pile and battery temperature scale
• Color-coded temperature compensation pass/fail chart
• Color-coded separate voltmeter and ampere meter
WARNING!
• Variable load carbon pile testers produce heat when in use. Take care to allow sufficient
time to cool down between tests to avoid injury due to heat build up.
• Be sure load is off before attaching or removing clamps to prevent arcing or potential
explosion from battery gasses. Always shield eyes and keep any sparks away during
testing.
OPERATIONAL INSTRUCTIONS:
1. Place the tester HORIZONTALLY on a stable surface.
2. Rotate the knob counterclockwise to ensure the load is on the “OFF” position. Connect the
RED clamp to the POS. (+) terminal of the battery, then the BLACK clamp to the NEG (+)
terminal. DO NOT REVERSE HOOK-UP.
3. Check battery status of charge.
4. Rotate the knob clockwise quickly to apply load to battery equal to 1/2 CCA rating or 3 times
the hour rating. Read on ampere meter.
5. Hold load for about 15 seconds.
6. When the buzzer in the tester sounds, read voltage and then turn off load.
7. Disconnect the clamps and store them.
Page of 4
3
TEMPERATURE COMPENSATION CHART:
(Refer to the color-coded chart on the side of the tester.)
BATTERY LOAD TESTER
TEMPERATURE COMPENSATION CHART
Page of 4
4
Distributed by
Northern Tool + Equipment Co., Inc.
Burnsville, Minnesota 55306-6936
Made in China
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Wel-Bilt Please see replacement item# 37805. 500 Amp Battery/Carbon Pile Tester Owner's manual

Brand
Wel-Bilt
Model
Please see replacement item# 37805. 500 Amp Battery/Carbon Pile Tester
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents