2. Delmhorst
  3. BDX-30
BDX-30

Delmhorst BDX-30, BDX-20, JX-20, JX-30 Operating instructions

  • Hello! I have reviewed the instructions for tether attachment for the Delmhorst BDX series moisture meter, specifically the Navigator BDX-30 model. This document describes how to attach cords to both the pin and connector caps. I'm ready to assist you with any questions you have about the tether installation process or the device itself.
  • What is the purpose of the nylon cords included with the meter?
    Where should the knot be located after tying it on the tether?
    Do I need to repeat these steps for both caps?
INSTRUCTIONS - Tether Attachment for the BDX Series Moisture
Meter
Each meter includes two short pieces of nylon cord to tie into tethers for
the pin and connector caps, if desired.
Step 1 – Remove the connector cap.
Step 2 – Thread one end of the Tether through the cavity of the meter.
Step 3 – Feed both ends through the top side of the connector cap.
Step 4 – Tie a single knot on the end of the Tether.
Step 5 – Slide the connector cap to the end so that the knot is inside and place
the cap back onto the meter as shown.
Step 6 – Remove the Pin Cover Cap and repeat the same steps.
Rev. 6-16-2021-1
/