2. Home
  3. Lighting
  4. Outdoor lighting
  5. Pro-Elec
  6. PEL00830

Pro-Elec PEL00830 Operating instructions

  • Hello! I've reviewed the instructions for the Plastic Garden Lamp model PEL00830. This document provides information on safe installation, and operation, and how to maintain the product. The lamp uses a GU10 7W LED bulb and has an IP44 rating. I'm here to help with any questions you might have about this device.
  • What type of lamp does this device use?
    What is the IP rating of this device?
    What is the recommended way to clean this device?
1
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
Safety Information for Installation and Operation
• Avoid excessive force when installing.
• Always install on a surface that can support the weight of the xture.
Plastic Garden Lamp
Model: PEL00830
2
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area. Made in China. PR2 9PP
Man Rev 1.0
SPECIFICATIONS
CLEANING AND MAINTENANCE
• Clean only with a soft, dry cloth. Do not use any chemicals, abrasives or solvents
that may damage the product.
• Unscrew the retaining screw and remove the
main assembly from the wall mounting.
• Turn off or isolate the mains supply.
• Feed the supply wiring through the access
point in the wall mounting.
• Attach the mounting to the wall using a suitable
mounting method.
• Offer up the main assembly and connect the
mains supply wires to the terminal block.
• Connect the positive supply wire (brown or red) to
the terminal marked L.
• Connect the neutral supply wire (blue or black) to
the terminal marked N.
• Clip the terminal block into the wall mount and ret
the main assembly onto the wall mount and replace
the retaining screw.
• Loosen the 4 allen screws in the lower corners of the
diffuser and lower the diffuser out.
• Fit an appropriate lamp GU10 Max 7W (not supplied).
• Ret the diffuser and secure the 4 allen screws.
• Restore the mains supply.
INSTALLATION
5
3
4
2
1
67
Voltage 220-240V~50Hz
IP rating IP44
Lamp type GU10 7W LED
/