Ignis ADL 441 NB is a dishwasher designed to make cleaning your dishes easier and more efficient. It features a range of programs to suit different types of loads, including a quick wash for lightly soiled dishes and an intensive wash for heavily soiled pots and pans. The Half Load option is ideal for smaller loads, and the Pre-Rinse program can be used to rinse dishes before a full wash cycle. The dishwasher also has a number of features to help ensure your dishes are cleaned thoroughly, including a rinse aid dispenser and a water softener.
Ignis ADL 441 NB is a dishwasher designed to make cleaning your dishes easier and more efficient. It features a range of programs to suit different types of loads, including a quick wash for lightly soiled dishes and an intensive wash for heavily soiled pots and pans. The Half Load option is ideal for smaller loads, and the Pre-Rinse program can be used to rinse dishes before a full wash cycle. The dishwasher also has a number of features to help ensure your dishes are cleaned thoroughly, including a rinse aid dispenser and a water softener.
NEU/II/B/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
/ OFF button.
Compartment
A:
With each wash cycle.
Compartment
B:
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator
C
.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator
D
. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.
If necessary (and if provided).
The corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
Only after the START button has switched off: Press the ON /
OFF
button.
All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
Fill the detergent dispenser
ABC
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Close the dishwasher door,
turn on the water tap
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the
START button again.
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
NEU/III/GB
Dishwasher loading instructions and racks provided
Upper rack:
Fold down glass holder (A):
Depending on the position, for example small or
long-stemmed glasses.
Crockery holders (B):
Depending on the position, for example plates, cups
and long-stemmed glasses.
Long-handled utensils (e.g. carving forks, knives)
must be arranged with the sharp end facing in
towards the appliance.
Lower rack:
Plate holders
(C)
.
Cutlery basket (D):
A grid
(E)
can be fitted onto the cutlery basket to keep
items separated.
Sharp knives and forks that might cause injury
must be placed in the cutlery basket with the
sharp end facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for
washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated
crockery (unglazed), silver cutlery.
NEU/IV/GB
What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see
also the corresponding chapter in the user instructions).
Problem Cause Remedy
The appliance is not
working
• No water supply. • Open the tap.
• The appliance does not load sufficient
water.
• Clean the water supply tap filter.
• Ensure there are no kinks in the water hose.
• There is a power failure. • Insert the plug into the mains socket.
• Press the Start button.
• Close the door.
• Check the safety circuit breaker.
• Starting the selected programme. • The programme can be set to “0” to start.
If crockery is not
perfectly dry
• Insufficient rinse aid. •Increase dosage *.
• Residual water in cavities. • Load crockery at an angle.
If crockery is not
perfectly clean
• The water jet does not reach the
crockery.
• Arrange crockery so that items do not touch each
other. Load crockery upside down.
• Insufficient detergent. • Follow recommended detergent dosage.
• Unsuitable programme. • Select a more intense wash cycle.
• Spray arms blocked. • The spray arms must be able to turn freely.
• Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *.
• Incorrect detergent/detergent too old. • Use a good quality detergent.
Sandy or grainy
residues
• Clogged filters. • Check filters regularly/if necessary clean *.
• Filters incorrectly assembled. • Insert the filter correctly *.
Colour of plastic parts
faded
• Tomato/carrot juice, ... • Depending on the material, if necessary use a
detergent with a greater whitening power.
Deposits on crockery
•Removable • Streaks on the crockery/glasses. • Increase the rinse aid dosage *.
• Streaks on glasses. • Reduce the rinse aid dosage *.
• Layer of salt on crockery/glasses. • Close the salt container lid properly *.
• Not removable • Insufficient water softening, calcium
deposits.
• Change water hardness setting, if necessary add salt *.
Opaque glasses/ glasses
not sparkling
• Cannot be washed in the dishwasher. • Use suitable glasses.
Rust on cutlery
• Not made of stainless steel. •Use suitable cutlery.
Identifying appliance
faults
• The START indicator lamp flashes.
• Indicator F... (if provided).
• Ensure the filter assembly is not clogged and that
there is no interruption to the water supply
(if necessary, clean the filters *). Start the programme
again. Press the START button for 2 seconds, until the
START indicator lamp switches off. Select a new
programme and press the Start button again.
If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water
supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
• The nature of the fault
• The appliance type and model
• The service code (the number indicated on the adhesive rating plate)
inside the door on the right-hand side.
5019 596 01000
GB
ADL 441
Quick Reference Guide
Before using the dishwasher, read the user instructions!
NEU/I/B/GB
(We reserve the right to make technical modifications)
1) Reference programme for energy label EN 50242;
2) Refer to “User instructions”;
3) The data relevant to programmes are values
obtained in the laboratory in conformity with
Standard EN 50242. In practice there may be time
variations or leaps depending on different loads,
function options, sensor calibration (only for sensor-
controlled programmes) water temperatures or
hardness and different power supply voltages.
Programme selector knob
On / Off button
Start button
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end
of the programme.
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B Litres kWh Minutes
Pre-Rinse cold
Crockery to be washed later. - - 5.0 0.02 10
Quickwash 40°C
Lightly soiled crockery with no
dried-on food.
X - 13.0 0.70 30
Bio
1)
50°C
Normally soiled crockery. X X 16.0 1.05 170
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X X 17.0 1.65 145
Half Load 50°C
Ideal for washing a half load of
lightly or normally soiled
crockery.
X X 13.0 1.00 130
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
-
1
-
2
-
3
-
4
Ignis ADL 441 NB Program Chart
- Type
- Program Chart
- This manual is also suitable for
Ignis ADL 441 NB is a dishwasher designed to make cleaning your dishes easier and more efficient. It features a range of programs to suit different types of loads, including a quick wash for lightly soiled dishes and an intensive wash for heavily soiled pots and pans. The Half Load option is ideal for smaller loads, and the Pre-Rinse program can be used to rinse dishes before a full wash cycle. The dishwasher also has a number of features to help ensure your dishes are cleaned thoroughly, including a rinse aid dispenser and a water softener.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI