INSTALLING BLOWER AFTER MOUNTING THE
FIREPLACE
Note: Fireplace must be properly connected to a 110V power source
before blowers can be operated.
1. Remove three screws that secure side brick retainers. Pull out
sidebrickexposingblowercoverplateonrightsideofreplace
(see Figure 5).
2. Remove blower cover plate (see Figure 6).
3. Placeblowerassemblythroughholeinrebox.Makesurewire
protrudesthroughnotchinreplaceside.Aligntwoholeson
side of rectangular bracket with two holes on side frame. Secure
withscrewsprovided(seeFigure7).Blowerassemblyshould
now look similar to Figure 8.
4. Beforereplacingblowercoverplate,plugmaleelectricalconnec-
toronblowerassemblyintofemalesocketalreadyinreplace.
Replaceblowercoverplate,sidebrickandretainerbeforeusing
replace.
SPECIAL INSTRUCTIONS FOR GLASS DOORS
Ifdoorsareinstalled,itisnecessarytoremovetherightdoorandsideframe.Toremovedoor,pressupperhingespringindoortrackand
slidetrackandslidedoorassemblytotheleft.Toremovesidedoorframe,removetopandlowermosthexheadscrewssecuringframe.
Figure 8
ON/OFF Switch
Fireplace Face
Figure 7
Figure 6Figure 5
Side Brick
Side Brick
Retainer
Fan
Cover
Plate
Knockout
Plate
Rectangular
Bracket
Rectangular
Bracket
Fireplace
Side
Fan Assembly
Firebox
56105
Rev. C
01/06
NOT A UPC
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
For more information, visit www.desatech.com
ON/OFF
Switch Wiring