Artec Power Brick Owner's manual

Thomann GmbH

Hans-Thomann-Str. 1 • 96138 Burgebrach

Germany • www.thomann.de

DocID: 108400_13.09.15

9 Individually regulated 8 outputs DC Power Distributor for effect pedals

9 1 Ampère high current switch mode wallplug AC adaptor included

9 8 pcs DC cable set included (2 x short / 3 x mid / 3 x long)

9 2 x 6 - 12 V DC, 100 mA adjustable voltage output

9 6 x 9 V DC, 100 mA xed voltage output

9 Individual output status indicator LEDs

9 Short protect / hum lter / common ground

9 3 blue LEDs for pedal board illumination

9 Low input power indicator LED

9 Dimension (L x W x H): 140 x 125 x 75 mm (box), 115 x 71 x 35 mm (unit)

POWER BRICK 8-way power supply

 Do not operate or store the unit in locations,

where it is exposed to precipitation, high

humidity, pollution, or strong vibrations.

Indoor use only!

 Never try to dismantle or repair the unit by

yourself in case it doesn‘t work.

 Never connect devices to the POWER BRICK,

that need another power supply voltage than this

unit can provide.

 Never use solvents like alcohol etc. for cleaning

the unit.

 Ensure that plastic bags, packaging, etc. are

properly disposed of and are not in the reach of

babies and young children. Choking hazard!

 Do not just dispose of packaging materials with

your normal household waste, but make sure that

they are fed to a recovery.

 At the end of its operating lifetime, do not dispose

of the device with your normal household waste.

This device is subject to the European directive

2002/96/EC. Dispose of this device through an

approved waste disposal rm or through your

local waste facility.

 Dispose of the batteries according to national or

local regulations regarding hazardous waste.