Gibson 70-0002 Installation guide

Brand: Gibson

Model: 70-0002

Type: Installation guide

Installation Instructions

Patriot Series Black Ceramic Cat-Back Stainless Split Rear Exhaust

Jeep JL Wrangler 3.6L ,V6 4wd

Part #70-0002

C C

ITEM

PART

QUANTITY

DESCRIPTION

999700998S-B

CFT Muffler Assembly

5762

2.5” Clamp

71-1010

4.0” Black Ceramic Tip

999700996S

Xtreme Terrain Tip

999700995S

Head pipe

Thank you for purchasing our Gibson Exhaust System for your vehicle.

If you need further assistance, please do not hesitate to call our technical department at

(800) 528 -3044 Monday through Friday, 8am to 5 pm.

1.Be sure to check all parts

are correct and match the

Manual. Loosen the factory

OEM clamp located just in

front of the muffler above

the factory axle. This will

require a 15MM.

5. Slide the second supplied

2.5” band clamp over the

headpipe then slip your new

Gibson muffler onto the

headpipe, tighten aluminum

hangers into their locations

with the 4 factory bolts.

2.Remove the factory

exhaust hangers from the

using a 13 mm removing the

two bolts. These hangers

will remain attached to

factory muffler when being

removed.

6. Slide the 2.5” band clamp

over the expanded part of

the muffler and make clamp

snug but not tight. Install

the Gibson provided tips.

Check for exhaust clearance

before tightening.

3. Once you have removed

the OEM exhaust install

Item# E onto the factory

oem pipe. Use clamp # b to

secure. Be sure notch is

lined up and do no tighten

clamp.

7. Adjust the tips to your

preference. Make sure

everything is clear of frame

rails and parts and re tighten

the system starting from the

front clamp. Check

everything after each clamp

is tightened.

4. Remove hangers from

OEM exhaust using removal

pliers or large channel pliers

and re-install them on the

Gibson as shown. Using a

lubricant can aid in the

removal.

8. To install your XT Tip

simply remove the exhaust

from the Gibson head pipe

and re install the tip using

the same clamp and driver

side only hanger. Protect

your tips when in storage.

We do not want any dings

or dents.

When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the

vehicle, set parking brake, block tires and use safety glasses and gloves. Allow exhaust to cool before attempting

installation. Severe injury or burns could occur if safety measures are not taken. Disconnect the negative battery terminal

before removal of the OEM Exhaust

SUGGESTED TOOLS: 3/8” Drive Socket Wrench, ½” Deep Socket, 15 mm Deep Socket, Short 3/8” Drive Extension,

1/2“Wrench, Exhaust Hanger Removal Pliers or Large Channel Lock Pliers, Rubber Dead-blow Hammer, Anti-seize, Jack, and

Jack Stands

Installation Instructions #70-0002

GIBSON EXHAUST systems are designed on a factory stock vehicle.Any aftermarket products used in addition to our system could change

performance and sound levels of the exhaust. Make sure there is a 1” clearance from ALL rubber brake lines, shock boots, lines, tires, etc.

to prevent heat related damage or fire.

Gibson 70-0002 Installation guide

Gibson 70-0002 Installation guide

Gibson 70-0002 Installation guide

Related papers

Other documents