2. RAMPAGE PRODUCTS
  3. 5307

RAMPAGE PRODUCTS 5307 Installation guide

  • Hello! I've reviewed the installation instructions for the Rampage Products Diamond Brite Taillight Kit, model 5307. This document provides a step-by-step guide on installing the taillight kit, including removing the old lens, inserting the new reflector, and installing the new lens. I'm ready to answer your questions about the taillight kit or the installation process.
  • How many screws need to be removed to take the taillight lens off?
    Do I need to remove the housing from the vehicle during installation?
    What should I note about the bulbs during removal?
Rampage Products 9225 Stellar Ct Ste “C”, Corona, CA 92883 Phone: (951) 277-4949 Fax: (951) 277-2295
www.rampageproducts.net
Installation Instructions
Diamond Brite Taillight Kit
Part # 5307
Step # 1
Remove taillight lens, 4 screws
remove Bulbs, (note there are two
dierent bulbs) and Center Divider;
it is not necessary to remove the
housing from the vehicle.
Step # 2
Insert new reector,
line up tabs on both
sides of housing,
reector may be snug,
but will slide in tightly.
Step # 3
Install bulbs and the new lens
You’re done, Enjoy your
new look.
/