2. Fishbone Offroad
  3. 550 Paracord Door Pull Straps

Fishbone Offroad 550 Paracord Door Pull Straps Installation guide

  • Hello! I've reviewed the installation instructions for the FISHBONE OFFROAD ParaCord Door Handles FB55285 & FB55286 for the 97-06 TJ Wrangler. This document details how to remove the old handles and install the new ones. I'm ready to answer your questions about the installation process.
  • What tools are required for installation?
    How many ParaCord Door Handles are included in the kit?
    Where are the door handles secured?
FB55285 & FB55286
97-06 TJ Wrangler
ParaCord Door Handles
REQUIRED TOOLS
T15 Torx Bit
Screwdriver OR
Body Clip Tool
KIT CONTAINS
ParaCord Door Handle QTY
2
FB55285 & FB55286
97-06 TJ Wrangler
ParaCord Door Handles
1
1) REMOVE
Open your vehicle’s door and locate the inner door
handle retaining bolts.
With a T15 Torx bit, remove these two bolts and
washers.
To remove the handle, simple pull it out and away.
2) INSTALL
The door handles are secured by nut clips on sheet
metal. To install your new handles, you will need to
separate the plastic panel from the metal, while
sliding the grommet in between the bolt hole and
nut clip.
To do this, use a screwdriver or similar to wedge
them apart, while avoiding knocking the nut clip off.
Once in place, reinstall the bolts and washers with a
T15 Torx Bit.
ENJOY YOUR FISHBONE OFFROAD PARACORD
DOOR HANDLES!
/