2. BLOTZ
  3. B06-MW-105

BLOTZ B06-MW-105 Assembly Instructions

  • Hello! I've reviewed the provided instructions for the BLOTZ 6mm 4x4 Cross/Shops model, specifically model B06-MW-105. This document includes assembly steps with the use of glue, sandpaper, and a knife. I'm here to answer any questions you may have about its construction.
  • What is required to stick sections together?
    What can be used to gently clean any joints?
    What is required to remove sections from the sprue?
6mm 4x4 Cross/Shops
B06-MW-105
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Take each of the wide wall sections and its brace
piece (shown on the left). Glue the brace to the
rear of the wall (shown on the right)
Take four of the shorter walls (shown above)
Attach the wide wall to the “roof”, then slide the
side walls into place on either side of it.
Move around the building repeating this for each
side.
Glue the decorative columns into place.
The completed building.
/