Rheem XE80T10HD50U1 Installation guide

Type
Installation guide

This manual is also suitable for

Instructions for Wi-Fi Enabled Gen-4 Controller
GET MORE FROM YOUR WATER HEATER
Congratulations! Your water heater has integrated Wi-Fi. To realize the full benefits of your water heater follow
these simple steps:
1. Download the Rheem EcoNet app via the App
Store or Google Play to your mobile device.
2. Create an account and sign in.
3. To enable WiFi, power on your water heater. On
the main screen, tap the WiFi icon to go to the
WiFi Status Screen.
4. On the WiFi Status Screen, tap ‘wifi setup’ in the
lower right corner.
5. On the Wi-Fi Setup screen, tap the ‘Get Started’
button.
6. Follow the instructions on the screen. Wait for
“Ready To Connect” to appear on the screen, then
complete setup using your mobile device.
wifi setup
WiFi Device Status. . . . . . . . . . . . . . . WiFi Disabled
WiFi Signal Strenght [dBm] . . . .
Econet WiFi sw Version . . . . . . .
WiFi Module sw Version . . . . . . .
MAC Address . . . . . . . . . . . . . . . .
SSID . . . . . . . . . . . . . . . . . . . . . . . . .
IP Address . . . . . . . . . . . . . . . . . . .
Subnet Mask . . . . . . . . . . . . . . . . .
Gateway . . . . . . . . . . . . . . . . . . . . .
StatusSettings Service Mode
Water Heater Off Mode
wifi status
Ready To Connect
wifi statussetup in progress
Wi-Fi Setup
Would you like to connect to the Internet
for remote control, leak detection alerts,
and diagnostic alerts on your mobile device?
GET STARTED SETUP LATER
Wi-Fi Setup
° Download the EcoNet app on your mobile device
° Use the app to create an EcoNet account
° Tap “WiFi Setup” below if blinking
° When “Ready to Connect” appears at the top of this
screen use the mobile app to complete the setup process
wifi setup
WiFi Device Status. . . . . . . . . . . . . . . WiFi Disabled
WiFi Signal Strenght [dBm] . . . .
Econet WiFi sw Version . . . . . . .
WiFi Module sw Version . . . . . . .
MAC Address . . . . . . . . . . . . . . . .
SSID . . . . . . . . . . . . . . . . . . . . . . . . .
IP Address . . . . . . . . . . . . . . . . . . .
Subnet Mask . . . . . . . . . . . . . . . . .
Gateway . . . . . . . . . . . . . . . . . . . . .
StatusSettings Service Mode
Water Heater Off Mode
wifi status
Ready To Connect
wifi statussetup in progress
Wi-Fi Setup
Would you like to connect to the Internet
for remote control, leak detection alerts,
and diagnostic alerts on your mobile device?
GET STARTED SETUP LATER
Wi-Fi Setup
° Download the EcoNet app on your mobile device
° Use the app to create an EcoNet account
° Tap “WiFi Setup” below if blinking
° When “Ready to Connect” appears at the top of this
screen use the mobile app to complete the setup process
wifi setup
WiFi Device Status. . . . . . . . . . . . . . . WiFi Disabled
WiFi Signal Strenght [dBm] . . . .
Econet WiFi sw Version . . . . . . .
WiFi Module sw Version . . . . . . .
MAC Address . . . . . . . . . . . . . . . .
SSID . . . . . . . . . . . . . . . . . . . . . . . . .
IP Address . . . . . . . . . . . . . . . . . . .
Subnet Mask . . . . . . . . . . . . . . . . .
Gateway . . . . . . . . . . . . . . . . . . . . .
StatusSettings Service Mode
Water Heater Off Mode
wifi status
Ready To Connect
wifi statussetup in progress
Wi-Fi Setup
Would you like to connect to the Internet
for remote control, leak detection alerts,
and diagnostic alerts on your mobile device?
GET STARTED SETUP LATER
Wi-Fi Setup
° Download the EcoNet app on your mobile device
° Use the app to create an EcoNet account
° Tap “WiFi Setup” below if blinking
° When “Ready to Connect” appears at the top of this
screen use the mobile app to complete the setup process
wifi setup
WiFi Device Status. . . . . . . . . . . . . . . WiFi Disabled
WiFi Signal Strenght [dBm] . . . .
Econet WiFi sw Version . . . . . . .
WiFi Module sw Version . . . . . . .
MAC Address . . . . . . . . . . . . . . . .
SSID . . . . . . . . . . . . . . . . . . . . . . . . .
IP Address . . . . . . . . . . . . . . . . . . .
Subnet Mask . . . . . . . . . . . . . . . . .
Gateway . . . . . . . . . . . . . . . . . . . . .
StatusSettings Service Mode
Water Heater Off Mode
wifi status
Ready To Connect
wifi statussetup in progress
Wi-Fi Setup
Would you like to connect to the Internet
for remote control, leak detection alerts,
and diagnostic alerts on your mobile device?
GET STARTED SETUP LATER
Wi-Fi Setup
° Download the EcoNet app on your mobile device
° Use the app to create an EcoNet account
° Tap “WiFi Setup” below if blinking
° When “Ready to Connect” appears at the top of this
screen use the mobile app to complete the setup process
AP19402
  • Page 1 1

Rheem XE80T10HD50U1 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI