Installation
A. Remove original cutting edge.
B. Place Rubber Cutting Edge (3) between plow and
original cutting edge (turned upside down) and
fasten using 1/2-13 x 3-1/2” Bolt C (1) and 1/2-13
Locknut (2).
C. Adjust Rubber Cutting Edge (3) as far up as
possible and tighten. The slots are for adjustability
as the Rubber Cutting Edge wears.
Installation Instructions
Part No. 08265 Rubber Cutting Edge Kit
Part No. 08266 Polyurethane Cutting Edge Kit
Installation & Operation
© 2010 Printed in the U.S.A.
The Home Plow
18513 Euclid Ave. • Cleveland, Ohio 44112-1084
Phone 877-412-PLOW (7569)
email info@thehomeplow.com
The Home Plow assumes no responsibility for installations not made in accordance with these instructions.
The Home Plow reserves the right, under its continuing product improvement program, to change construction or design details, specifications
and prices without notice or without incurring any obligation.
Form 1-1011
December 2010
1
2
3
Original
Cutting Edge
1
2
3
4
Item Part No. Qty Description
08265 1 Rubber Cutting Edge kit
08224 1 • Hardware Bag
1 22309 12 •• Bolt C 1/2-13 x 3-1/2”
2 20307 12 •• 1/2-13 Locknut
3 13076 1 • Rubber Cutting Edge
Item Part No. Qty Description
08266 1 Polyurethane Cutting Edge kit
08224 1 • Hardware bag
1 22309 12 •• Bolt C 1/2-13 x 3-1/2”
2 20307 12 •• 1/2-13 Locknut
3 12708 1 • Polyurethane Cutting Edge
4 12707 1 • Bar Strap
Installation
A. Remove original cutting edge.
B. Place Polyurethane Cutting Edge (3) between plow
and Bar Stop (4) and fasten using 1/2-13 x 3-1/2”
Bolt C (1) and 1/2-13 Locknut (2) and tighten.
08265
08266
