Page is loading ...
H O W T O
INSTALL YOUR
I tem # CH-1 1 0 0
ADJUSTABLE DRINK HOLDER
FOR STAR ROLLING WALKERS
1
2
3 4
WHAT’S IN THE BOX
a. (1) Folding Cup Holder
b. (1) Assembly Mount Set
c. (1) Rubber Mat
d. (1) Screw & Washer Set
a. b. c. d.
TOOLS NEEDED
Philips Screwdriver
Peel off adhesive on back of rubber
mat, and wrap around the location
where cup holder is to be installed
(Figure 1).
Attach folding cup holder on
inner plastic gear and ensure the
base of the cup holder is parallel
to the ground (rotate cup holder
to adjust along gear if needed).
Secure with washer and small
screw (Figure 3).
Place the assembly mount set around the
rubber mat to secure position. Ensure that
inner plastic gear of the mount faces the side
the cup holder will attach to (Figure 2). Insert
two screws through the mount and tighten.
Drink holder is designed to collapse down to
convenient size (Figure 4). Swing the clamps down,
and flip up the base to fold the drink holder.
Drink holder can be adjusted by sliding the two
clamps to the appropriate size.
Figure 1
Figure 2
Figure 3
Figure 4
rubber mat
inner plastic
gear
2
1
Revised February 22, 2018
Quick installation
/
