IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when
children are present, basic safety precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
— Any appliance is electri-
cally live even when the switch is off. To reduce
the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquid.
5. If an appliance falls into water, unplug it im-
mediately. Do not reach into the water.
WARNING
— To reduce the risk of
burns, electrocution, fi re, or injury to persons:
1. This appliance should never be left unat-
tended when plugged in.
2. Do not pull, twist, or wrap line cord around
appliance.
3. This appliance should not be used by, on or near
children or individuals with certain disabilities.
4. Use this appliance only for its intended use, as
described in this manual. Do not use attachments
not recommended by the manufacturer.
5. Never operate this appliance if it has a dam-
aged cord or plug, if it is not working prop-
erly or if it has been dropped or damaged, or
dropped into water. Return the appliance to
an authorized service center for examination
and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any open-
ing or hose.
9. Do not use outdoors or operate where aerosol
(spray) products are being used or where oxygen
is being administered.
10. Unit is hot when in use. Do not let eyes or
bare skin touch heated surfaces.
11. Do not place the heated unit directly on
any surface or on the appliance cord while it
is hot or plugged in.
12. Never block the air openings of the appliance
or place on a soft surface, such as a bed, couch,
or towel, where the air openings may be blocked.
Keep the air openings free of lint, hair, and the
like. Unplug before storing.
13. Do not use an extension cord with this
appliance.
14. Do not touch hot surfaces of the appliance.
Use handles or knobs.
15. Before plugging in read the information about
dual voltage contained in the instruction section
of this manual.
16. Do not attempt to touch the housing of your
appliance near the straightening plates as it is
hot when in use.
17. Do not use with a voltage converter.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron is intended for house-
hold use. This unit is designed to operate at
120/240 volts AC. Use on Alternating Current
(50/60 hertz) only.
This appliance has a polarized plug (one blade is
wider than the other). As a safety feature, this plug
will fi t in a polarized outlet only one way. If the plug
does not fi t fully in the outlet, reverse the plug. If
it still does not fi t, contact a qualifi ed electrician.
Do not attempt to defeat this safety feature.
DUAL VOLTAGE
This straightening iron will automatically adjust
to the proper voltage. Use an adapter plug with
correct confi guration, prior to use in outlet.
TO STRAIGHTEN HAIR
Hair should be clean and completely dried before
using the straightening iron. Plug the iron into an
electrical outlet. Turn on unit. The power indica-
tor light should become illuminated. Allow unit
to heat up for several minutes.
WARNING: The straightening iron’s plates will
get very hot within a few seconds and should
not be placed in contact with the skin after
the straightening iron has been turned on.
GETTING STARTED
The straightening iron’s 3 high heat temperature
settings and Instant Heat technology combine to
provide styling versatility for all hair textures. If
you have fi ne hair, a low temperature will provide
the best results. If you have thick, wavy or hard-
to-straighten hair, keep the heat setting high. You
can vary the straightening iron’s temperature
according to your particular need!
STRAIGHTENING BASICS
1. Plug the straightening iron cord into any house-
hold outlet (120/240V, red light to go on). Press
ON button. The iron will heat up very quickly. The
red indicator light will stop blinking and remain
on when the iron is ready to use. To turn off, press
OFF button (red light will go off). Never leave your
straightening iron on and unattended.
However,
should you fail to turn the unit off, it will shut
itself off automatically within 72 minutes.
2. Start with a hair section that is 2” wide and no
more than 1/2” thick. Open the iron and place a
hair section between the two hot plates, close to
the scalp. Trap hair between the plates by fi rmly
squeezing the handles together. While maintain-
ing the tension, slowly pull the unit down along
the hair section toward the end of hair. For best
results, use a light styling lotion before blow-dry-
ing hair. At the end of hair section, release the
pressure on the handle and allow the hair section
to slide out. Repeat process on additional sections
of hair until you achieve the hair style you desire.
It may be necessary to repeat process on certain
areas, depending on the texture of your hair.
Some experience is necessary when learning to
use this straightening iron. After using iron several
times, you will learn the ideal way to straighten and
style your hair easily.
STYLING WITH EASY-GLIDE TITANIUM-
TOURMALINE CERAMIC COATED PLATES
The plates of this premium straightening iron
are coated with a combination of the best ma-
terials for styling. A fusion of titanium, tourma-
line and ceramic evenly distributes heat to
gently style and protect hair from damaging
hot spots. When heated, tourmaline naturally
emits clouds of negatively charged ions that
eliminate fl yaways and frizzies and leave hair
silky smooth and shiny.
Hair glides easily over the surface of these ultra
smooth plates. As you straighten each strand,
you’ll achieve a salon-perfect fi nish.
Plates are exceptionally easy to clean, and you’ll
discover this combination of technologies leaves
your hair silky smooth.
USING INSTANT HEAT, THE 3 HIGH HEAT
TEMPERATURE SETTINGS AND UNIFORM
HEAT RECOVERY SYSTEM
This straightening iron features Conair’s Instant
Heat technology.
Within this Instant Heat technology there are 3
temperature settings for every type of hair, from
the fi nest to the curliest and most resistant. Se-
lect the temperature range that’s suitable for your
hair type to help you create the look you want.
And that’s not all. Conair’s professional salon
standards of engineering provide you with a Uni-
form Heat Recovery System that maintains the
straightening iron at a constant temperature.
There is a constant surge of power to ensure that
heat is continuously delivered for optimal styling
results, unlike other units which lose heat during
use. This provides consistent styling power so
that every strand of your hair is set with the same
level of heat and comes out the same way for a
perfect fi nish.
REMOVABLE SILICONE
DEEP SHINE ATTACHMENT
Your straightening iron includes a removable
silicone deep shine attachment. This attachment
will help to provide tension and guide your hair
as you use the straightening iron. It also eliminates
any gaps, creating silky, smooth strands with
extra shine. To remove or attach the silicone strip,
turn unit off and allow unit to cool. Hold unit
fi rmly with one hand; with your other hand, slide
silicone strip away from the iron to detach it.
When attaching the silicone strip, align it with
the slot on the side of the iron and slide silicone
strip into position. Make sure the silicone strip
securely locks into position.
Temp. Setting Hair Type
Low Delicate, thin, easy-to-straighten hair
Medium Average to thick or treated hair
High Thick, wavy or hard-to-straighten hair
Temperature Setting Guide
08NP10404_CS64_ib.indd 108NP10404_CS64_ib.indd 1 11/25/08 1:50:17 PM11/25/08 1:50:17 PM