mothercare Booster Seat And Step Stool User guide

Type
User guide
booster seat
& step stool
user guide
Important! Keep for
future reference
introduction
This two height booster seat allows your child to sit with you whenever using
a table, by securing the booster on a suitable chair*.
Suitable for children who can sit unaided (around six to nine months) to
around 4 years.
When removed from the booster, the base can also be used as a step stool
(weight limit 50 kg maximum).
* Refer to section 6, safety notes for information on suitable types of chairs.
1
1
parts checklist
2
diagram description
upper seat & harness
lower seat / step stool
securing strap
preparation for use
3
3
2
1
2
With the upper seat upside down, pass
the ends of the securing strap through
the slots at the sides as shown.
Place the upper seat onto the base as
shown, and press down firmly to engage
the clips at the sides of the seat
(see diagram 3).
Ensure that the side clips have securely
engaged.
the securing strap
fixing the seat to the base
preparation for use
3
4
5
Position the booster on the chair*, wrap
the securing strap underneath, and fasten
the buckle.
* Refer to section 6, safety notes for
information on suitable types of chairs.
Tighten the securing strap underneath by
pulling on the end of the strap to remove
any slack.
Always check that the booster is secure
and stable before putting your child in.
fixing to the chair
3
in use
4
1
3
A
2
To fasten
Pass one end of the waist strap through the
loop on the crutch strap and insert the
fastener securely into the clasp.
To release
Squeeze the fastener prongs and pull apart.
Your child should be securely harnessed
at all times and should never be left
unattended, even for short periods.
the harness
Adjust the waist strap length with part A.
4
in use
4
1
2
adjusting the height
The height of the booster can be adjusted
for taller & older children by removing the
base.
Release the clips at both sides of the seat
and lift the upper seat off the base.
The booster can then be used on a seat by
securing as described on page 3.
the step stool
The base of the booster can be used as a
step stool simply by turning it over once
removed from the booster.
Ensure the step stool is only used on a level,
stable, non-slip surface.
The weight limit for the step stool is 50 kg max.
5
care of your product
5
6
The booster can be cleaned by sponging with warm water and a mild
detergent. A mild disinfectant may be used.
Stubborn marks may be removed with a non-abrasive cream cleaner. Never
clean with abrasive, ammonia based, bleach based or spirit type cleaners.
Periodically check for damage, including internally, and discontinue use if
any part is damaged or broken.
safety notes
6
WARNING! YOUR CHILD'S SAFETY IS YOUR RESPONSIBILITY.
The booster must be fully secured on the seat before placing a child inside.
Ensure the harness is correctly fitted and adjusted at all times.
When using the booster at a table, ensure the child cannot push against
the table or another chair, and tip the booster and chair over.
Keep away from trailing cords flexes, electric irons, ornaments and other
such hazards.
Do not use close to any source of heat.
Never use the booster in a vehicle as a car seat.
Do not move the booster or chair with the child inside.
Do not use if any part is broken, damaged or missing.
If the booster is used by someone unfamiliar with it e.g. grandparents
always show them how it is used.
Never leave your child unattended, even for the shortest time.
The recommended type of chair is as shown
left, with four legs, a high backrest, and
firm seat. If the chair has a cushioned seat,
check the securing strap periodically to
ensure it has not loosened.
Do not use the booster on a table top, stool,
swivel chair, folding chair or any other type
of chair that the booster cannot be firmly
secured to.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

mothercare Booster Seat And Step Stool User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI