ASSEMBLY INSTRUCTIONS
Remove all bolts (Da) and metal washers (Dc)
from legs (C).
Place the tabletop upside down and insert six
legs (C) into the plastic receivers on table rim (A),
working the legs in until the holes in the leg line up
with the holes in the receivers. Place the center
ring (B) between the legs (C) line up the in the
brackets of legs. For each hole, insert a bolt (Da)
through a metal washer (Dc), through the center
ring (B) and secure into the leg (C). Don’t tighten
completely. Repeat procedure for the remaining
five legs.
Insert a screw (Db) through each receiver and
secure into the tip of the leg.
Securely tighten all bolts diagonally by using Allen
wrench (Df) provided. Then turn the table over and
place the umbrella insert piece (Dd) into the
umbrella hole on the table when there is no use
of it.
Your table is now ready for use. Enjoy!
1
2
3
4
3
CARE INSTRUCTIONS
Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents.
Cover furniture with outdoor furniture covers when not in use.
Made in CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
For questions or comments about product:
Call toll-free:
800-457-4652
Please refer to part numbers when reordering
Dc
Db
A
B
C
Da
Da
Dc