Mazda 2006 MX-5 User manual

Brand: Mazda

Model: 2006 MX-5

Type: User manual

Mazda 2006 MX-5 is a high-performance sports car that delivers an exhilarating driving experience. It features a lightweight and aerodynamic design, a powerful and responsive engine, and a sharp and precise handling. The MX-5 is also equipped with a variety of features that enhance its performance and safety, including a limited-slip differential, dynamic stability control, and four-wheel disc brakes.

The MX-5 is a true driver's car that is sure to provide years of enjoyment behind the wheel. With its combination of performance, style, and affordability, the MX-5 is an excellent choice for anyone looking for a fun and engaging sports car.

Page 1 of 5

CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/

equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers

should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,

customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and

electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in

writing.

Subject:

CENTER CONSOLE LID WILL NOT STAY CLOSED

Bulletin No: 09-033/06

Last Issued: 7/21/2006

Service Bulletin

Mazda North American Operations

Irvine, CA 92618-2922

2006 MX-5 - CENTER CONSOLE LID WILL NOT STAY CLOSED

APPLICABLE MODEL(S)/VINS

2006 MX-5

DESCRIPTION

On some vehicles, the center console lid may not stay in the closed position due to a broken latch.

Customers having this concern should have the console lid replaced using the following repair procedure.

REPAIR PROCEDURE

1. Verify customer concern.

2. Remove the center console from the vehicle. Refer to Workshop Manual section 09-17 CONSOLE

REMOVAL / INSTALLATION.

3. Remove the cup holder from the center console. Refer to Workshop Manual section 09-17 CONSOLE DIS-

ASSEMBLY / ASSEMBLY.

4. Slide open center console lid fully to rear position.

5. Identify rear guides for console lid.

1653a

REAR GUIDES

FRONT GUIDES

CENTER CONSOLE LID

Bulletin No: 09-033/06

Last Issued: 7/21/2006

Page 2 of 5

6. Using a flat-tipped screwdriver, slide guides rearward to disengage tabs from sides of cup holder assembly

as shown.

7. Repeat for other side.

8. Carefully lift console lid and guides from cup holder assembly.

1653b

PLACE FLAT TIPPED SCREWDRIVER INT

SLOT AND SLIDE GUIDE TOWARD REAR

OF CUP HOLDER TO DISENGAGE TABS

(REPEAT FOR BOTH SIDES)

1653c

GUIDE TAB SHOWN ENGAGED

GUIDE TAB SHOWN DISENGAGED

Bulletin No: 09-033/06

Last Issued: 7/21/2006

Page 3 of 5

9. Remove guides from old console lid.

NOTE:

• Make note of sides of cup holder assembly guides are removed from for installation. Guides

cannot be installed backward or on opposite sides. Attempting to do so may damage the guides

and/or the cup holder assembly.

10.Install old guides onto new console lid. Line up with front edge of guides with front of lid.

11. Insert first tab of both guides into cup holder assembly.

PLACE GUIDES

ONTO NEW CENTER

CONSOLE LID

1653e

1653f

INSERT FIRST TAB OF BOTH GUIDES

INTO CUP HOLDER ASSEMBLY

Bulletin No: 09-033/06

Last Issued: 7/21/2006

Page 4 of 5

12.Carefully lay lid and guides down to line up remaining tabs.

13.Using a flat-tipped screwdriver, slide guide forward to engage tabs to sides of cup holder assembly.

14.Slide center console lid to fully closed position.

1653g

PLACE FLAT TIPPED SCREWDRIVER

INTO SLOT AND SLIDE GUIDE TOWAR

FRONT OF CUP HOLDER TO ENGAGE

TABS (REPEAT FOR BOTH SIDES)

1653h

GUIDE TAB SHOWN DISENGAGED

GUIDE TAB SHOWN ENGAGED

Bulletin No: 09-033/06

Last Issued: 7/21/2006

Page 5 of 5

15.Press down on rear of guides to ensure they are properly seated into cup holder assembly.

16. Install cup holder to center console.

17.Install center console to vehicle.

18. Verify repair.

PART(S) INFORMATION

WARRANTY INFORMATION

NOTE:

• This warranty information applies only to verified customer complaints on vehicles eligible for war-

ranty repair. Refer to the Warranty Wizard for warranty term information.

• Additional diagnostic time cannot be claimed for this repair.

Part Number Description Qty. Notes

NE51-64-390 -02 Center Console Lid Ass’y 1 Black

NE51-64-390 -89 Center Console Lid Ass’y 1 Tan

Warranty Type A

Symptom Code 64

Damage Code 9A

Part Number Main Cause SEE PART(S) INFORMATION

Quantity 1

Operation Number / Labor Hours: XXB337RX / 0.4 Hrs

1653i

FIRMLY PRESS DOWN ON REAR

OF GUIDES TO ENSURE REAR

TABS LOCK INTO POSITION

Mazda 2006 MX-5 User manual

Mazda 2006 MX-5 User manual

Mazda 2006 MX-5 User manual

Related papers

Other documents