SlipX Solutions 04118-1 Operating instructions

Brand
SlipX Solutions
Model
04118-1
Type
Operating instructions

SlipX Solutions 04118-1: Enhance bathroom safety with our innovative non-slip treads, designed to provide a secure grip and prevent slips and falls in the bathtub or shower. These treads are easy to install and maintain, requiring minimal effort to achieve a safer bathing experience.

SlipX Solutions 04118-1: Enhance bathroom safety with our innovative non-slip treads, designed to provide a secure grip and prevent slips and falls in the bathtub or shower. These treads are easy to install and maintain, requiring minimal effort to achieve a safer bathing experience.

Installation Instructions – Tub Tattoos
Installation Instructions
1. The first step is to decide how you want them to be laid out. The best way to get your
pattern right is to lay out all your treads or appliques on the tub without taking the
adhesive backing off. This way you can make sure you have full coverage.
2. Once you're satisfied with your layout, peal the backing off of the first applique.
3. Eliminate as many air bubbles as possible by pressing firmly starting in the middle and
working your way toward the edges. This will ensure consistent contact on the entire
surface.
4. Allow a minimum 4 hours of drying time before you use the shower. If possible, we
recommend that you give them a full 24 hours.
Easy and Effective Tread Installation
This applique installation guide applies to a variety of our products. If you are planning to
or have already purchased any of the following products, this guide is for you. If you have
purchased our recyclable bathtub treads, then these steps aren't required because they
use suction cups rather than adhesive.
Before you proceed with the installation below, ask yourself "Have I already properly
cleaned my tub?" If not then read our How to Clean and Prepare Your Tub guide.
Questions? www.SlipXSolutions.com or 1-800-968-0104
Installation Instructions – Tub Tattoos
Why Tub Surface Preparation is Important
Your geographical location, your family's bathing habits, and the hardness of your water
can all have an effect on how well bathroom products stay put in your bathtub or
shower. That said, if you follow the simple steps outlined below, your adhesive
appliques, tub tattoos, or non slip treads from Slip-X Solutions will stick securely and last
a long time. If for any reason you have trouble with our bathroom products after
following these instructions, simply contact us and we'll take care of you!
Bathtub Cleaning Procedure
1. Clean your tub as you normally would. Make sure not to use a silicon based cleaning
solution.
2. Thoroughly dry your tub, either by air or using a dry towel.
3. Wipe down your tub using rubbing alcohol and allow it to completely air dry.
These steps will insure that all soap residue and mineral build-up are removed from your
tub's surface. This will make sure the adhesive is in direct contact with the tub surface.
Additional Recommended Tips
- Allow at least 4 hours to dry before using the tub. If possible, we recommend waiting
a full 24 hours before using your tub.
- Some bath oils can be harmful to the adhesive, making it more likely for treads or
appliques to start pealing over time. To minimize this, make sure to pour all oils into a
tub already filled with water.
  • Page 1 1
  • Page 2 2

SlipX Solutions 04118-1 Operating instructions

Brand
SlipX Solutions
Model
04118-1
Type
Operating instructions

SlipX Solutions 04118-1: Enhance bathroom safety with our innovative non-slip treads, designed to provide a secure grip and prevent slips and falls in the bathtub or shower. These treads are easy to install and maintain, requiring minimal effort to achieve a safer bathing experience.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents