Loosen the
lever, adjust
the angle of
the R-09,
then lock
the lever
again.
Attaching the Cover
Attaching the Tripod
Attaching the Mic Stand Adapter (Optional OP-R09M)
Cover Stand Set for
OP-R09C OWNER’S MANUAL
OP-R09C
Fasten snap
Lash strap to
metal ring
Copyright ©2006 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
Tighten all of the
OP-R09M (optional)
sections to align
the entire unit.
Attach the adapter
to the threaded hole
in the rear of the cover.
Rotate the (optional)
mic stand until it is
completely tightened.
Loosen the screw as
shown, adjust the angle
of the R-09, then tighten
the screw again.
Spread out
the tripod
legs to
their fullest.
Completely
extend the
tripod legs.
Attach the
tripod to
the threaded
hole in the
rear of the
cover.
Grasp the R-09 with your fingers
when pressing the R-09’s buttons.
Tighten
the screw.
Insert the R-09. Fasten the snaps to
close the flap.
When Attaching to a Belt
When Attaching to a Carrying Strap
* Use the adapter as required
to match the diameter of the
mic stand’s screw.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT
NOTES.” These sections provide important information concerning the proper operation of the unit. Additionally,
in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s
manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.
USING THE UNIT SAFELY
001
• Before using this unit, make sure to read the instruc-
tions below, and the Owner’s Manual.
..........................................................................................................
002a
• Do not open or perform any internal modifications on
the unit.
..........................................................................................................
003
• Do not attempt to repair the unit, or replace parts within
it (except when this manual provides specific instruc-
tions directing you to do so). Refer all servicing to your
retailer, the nearest Roland Service Center, or an autho-
rized Roland distributor.
..........................................................................................................
013
• In households with small children, an adult should
provide supervision until the child is capable of following
all the rules essential for the safe operation of the unit.
..........................................................................................................
014
• Protect the product from strong impact.
(Do not drop it!)
104
• Try to prevent cords and cables from becoming
entangled. In addition, to prevent the equipment from
toppling and falling, arrange cords and cables so they
do not become pulled or snagged. Also, all cords and cables
should be placed so they are out of the reach of children.
..........................................................................................................
118b
• Keep the adapter screw included with the optional
special mic stand adapter in a safe place out of
children’s reach to prevent accidental ingestion.
..........................................................................................................
IMPORTANT NOTES
• Be sure the tripod is spread out adequately. This allows the
tripod to stand with greater stability.
• Use the setup in a flat, level location.
• Use the setup only after confirming the stability of all attached
devices. Avoid use in locations where wind or other conditions
may cause the equipment to topple and fall.
• Always detach the device from the tripod before moving it.
Carrying the device while it is still attached to the tripod may
cause the device to separate from the tripod and fall.
• Do not leave the device attached to the tripod. The topple and
fall, resulting in unanticipated damage to the unit.
• Take care not to allow fingers to become pinched when
extending and retracting the tripod legs.
* Roland assumes no liability whatsoever for any damages, loss of
income, or claims by any third party arising from the inappropriate
use of this product.
* Roland assumes no liability whatsoever for any damage to the device
resulting from the unit dropping or falling.
Placement
354a
• Do not expose the unit to direct sunlight, place it near devices
that radiate heat, leave it inside an enclosed vehicle, or otherwise
subject it to temperature extremes. Excessive heat can deform or
discolor the unit.
Maintenance
401a
• For everyday cleaning wipe the unit with a soft, dry cloth or one
that has been slightly dampened with water. To remove
stubborn dirt, use a cloth impregnated with a mild, non-abrasive
detergent. Afterwards, be sure to wipe the unit thoroughly with
a soft, dry cloth. Do not launder or wash the entire case.
402
• Never use benzine, thinners, alcohol or solvents of any kind, to
avoid the possibility of discoloration and/or deformation.
Specifications
Tripod (two-stage extending/retracting type)
• Retracted length: 98 mm
• Overall height in use: Approx. 90 mm
• Weight: 35 g
• Max. Load: 1000 g (vertical load)
962a
* In the interest of unit improvement, the specifications and/or
appearance of this unit are subject to change without prior notice.
201a 202
Used for instructions intended to alert
the user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic
animals or pets.
Used for instructions intended to alert
the user to the risk of death or severe
injury should the unit be used
improperly.
The ● symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In
the case of the symbol at left, it means that the power-
cord plug must be unplugged from the outlet.
The symbol alerts the user to important instructions
or warnings.The specific meaning of the symbol is
determined by the design contained within the
triangle. In the case of the symbol at left, it is used for
general cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never
be carried out (are forbidden). The specific thing that
must not be done is indicated by the design contained
within the circle. In the case of the symbol at left, it
means that the unit must never be disassembled.
OP-R09C_je.fm 3 ページ ２００６年４月１１日 火曜日 午前１１時５８分
1
