Connect transformer :
9
G
8
G
For safety reasons, every
lightline
system should only be pro-
vided with a power supply via a
lightline
transformer.
Switching two transformers in parallel is not permissible!
v Do not place the transformers in direct sunlight.
In Switzerland, mobile appliances which are used outdoors,
must be connected via a fault current circuit-breaker.
The GARDENA Underwater Light and plug and socket connec-
tions are designed solely for operation with a 12 V low voltage
supply.
Connection to 230 V can endanger your life !
v Do not carry the light and the transformer by the cable and
do not use the cable to pull the plug out of the socket.
Protect the cable from heat, oil and sharp edges.
v Unplug for winter storage, when not in use and before main-
tenance.
The temperature of the pond water must not be below 4 °C or
above 35 °C.
v Inspect before use to establish whether the light is damaged.
Do not use a damaged light. If damaged, have the light checked
by GARDENA Service or an approved electrician.
For Switzerland
Mains voltage
Temperature range
Inspect before use
Purpose
Please note
GARDENA Underwater Light
Welcome to the garden of GARDENA ...
Please read and follow these operating instructions carefully.
Use these instructions to use the Underwater Light correctly and
observe the safety information.
For safety reasons, children and young people under 16 years
of age and people who are not acquainted with these operating
instructions should not use this Underwater Light.
v Please keep these operating instructions in a safe place.
1. Range of Uses for Your GARDENA Underwater Light
. . . . . . . . . 8
2. For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
3. Assembly for Use as an Upright Light
. . . . . . . . . . . . . . . . . . . . . . . . . 9
4. Initial Operation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
5. Maintenance
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
6. Trouble-Shooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
7. Winter Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
8. Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
9. Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
1. Range of Uses for Your GARDENA Underwater Light
The Underwater Light is part of the GARDENA
lightline
range and
is intended for use as underwater lighting for your garden pond.
GARDENA
lightline
is a 12 V low voltage system for lighting your
garden, patio and ponds.
Warning! GARDENA
lightline
lights, cables, control equip-
ment and plug and socket connections are designed solely
for operation with a 12 V low voltage system. Connection
to a 230 V supply can endanger your life!
Contents
2. For Your Safety
The Underwater Light must only be operated when floating on
water or when under water. Do not use the light when out of
water.
The transformer must be operated via a fault current circuit-
breaker (FI-switch) with a nominal fault current ≤ 30 mA (DIN
VDE 0100-702 and 0100-738).
v Please ask an electrician.
The data on the type plate of the transformer must match the
data for the power supply.
v Ensure that the transformer is positioned in a place safe from
flooding and at least 2 m away from the edge of the pond.
Operating the
Underwater
Light
Using the transformer
3. Assembly for Use as an Upright Light
The Underwater Light can be used as an upright light or as a float-
ing light (see 4. Initial Operation). The light has to be assembled
for use as an upright light.
1. Depending on the height required, push up to 3 parts of the
supporting leg
1
with the narrower side upwards on to the
connection cable
2
for the light.
2. Push the sections of the support
1
on to the shade holder
3
from below.
3. Pull the connection
cable
2
through the
base
4
.
4. Push the base
4
on to
the support
1
.
5. Clamp the connection
cable
2
between the
2 projections
5
on
the underside of the
base
4
and route
through the guide
6
.
4. Initial Operation
V Please read the operating instructions for installation of
the relevant GARDENA
lightline
transformer and using
it for the first time.
Assemble upright light :
4
3
1
2
4
6
5
2