How to start a 12v vehicle:
1. Make sure the unit is fully charged.
2. Turn off all the accessories on the vehicle.
3. Disconnect the battery cables from the unit.
4. Connect the RED clamp to the positive post of the battery.
5. Connect the BLACK clamp to the negative post of the battery.
6. Connect the battery cables into the jump cable port. Be sure that the plug is firmly
pressed into the unit.
7. When the vehicle is started, remove the jumper cable from the vehicle battery. Leave
the vehicle’s engine running.
Note: If the vehicle does not start on the first try, wait for 1 minute before tying
to start the vehicle again.
ATTENTION
To avoid injury and/or damage to your vehicle, do not connect the red and black
clamps together.
Remove battery within 30 seconds of starting your car.
Keep out of reach of children.
The non- professional do not dismantle products.
Don't use the product at a high temperature or place it for a long time under a high
temperature environment . The Discharge Temperature : -20℃ ~ 40℃, Charge
Temperature : 0℃ ~ 45℃.
Prohibit the use of non-original charger to charge the product.
Use the original battery clamp with smart-protection to jump start the car.
Please do not repeatedly jump start the car with large engine size in short time
If products can't charged properly or the emergencies happen when you using
products to start the car, please discontinue use immediately and find us to help you.
For Optimal Use
Charge battery at least once every months to avoid shortening its lifespan.
Recharge your vehicle's battery as soon as possible after jump starting.
Warranty