Dyco DYC9040/5 User manual

Brand
Dyco
Model
DYC9040/5
Type
User manual

This manual is also suitable for

Sun Paints & Coatings / Dyco Paints • 5850 Ulmerton Road • Clearwater, FL 33760
Phone: 1-800-282-7901 • Facsimile: 727.536.0561 • www.SunPaintsAndCoatings.com
B-15
R-1i
DYC9040
TUFF GRIP BONDING COAT
9040 Data Sheet
CHARACTERISTICS
Tuff Grip Bonding Coat is a waterborne epoxy ester tie coat
formulated to penetrate, fortify and prepare slick steel
troweled non-porous bare concrete and cured asphalt.
This product is also a superior bonding primer for previ-
ously painted deck surfaces.
RECOMMENDED USES
Deck Coating Bonding Primer for:
•
Bare Concrete Decks
•
Cured Asphalt Surfaces
•
Previously Painted Deck Surfaces
FEATURES/BENEFITS
•
Excellent Alkali Resistance
•
Forties and Reinforces
•
Superior Adhesion to Bare Concrete
•
Low VOC’s
•
Easy Soap and Water Clean Up
SPECIAL NOTES
New Concrete must be fully cured, 30-45 days Surface
must be clean and dry air temperature should be at least
50°F (10°C). Product must be Top Coated within 5 Days
For a non-skid surface use Dyco #44 Skid Gard Do not ap-
ply this product to a Bomanite Surface
FOR ADDITIONAL INFORMATION
See MSDS or call toll-free 1-800-282-7901.
TECHNICAL DATA
Vehicle Type ...................... Waterborne Epoxy Ester
Finish/Sheen .................... Low
Solids by Weight ................ 29%
Solids by Volume ............... 25%
Viscosity ........................... 80 ± 2 KU
VOC
(less exempt solvents)
............. 310 g/L.
Weight per Gallon .............. 8.64 lbs/gal.
COVERAGE
350 S.F./Gal. @ 4 mils Wet; 1.44 mil DFT
(Actual coverage may vary depending on type of sub-
strate, and application method.)
COLOR
•
9040 Transparent Amber
KEY ATTRIBUTES
Application Temperatures: 50 - 110°F (10 - 43.33°C)
Application Tools: Brush, Roller, or Spray
Dry Times: Touch - 2-3 Hour; Recoat - 8 Hours
(Dry Time Based on 77°F (25°C), 50% RH)
Thinner: 8oz. per gallon max. for non-porous concrete.
Clean Up: Warm Soapy Water
PHYSICAL PROPERTIES
Mildew Resistance ..Excellent
Flash Point ..............145°F (62.77°C)
Sun Paints & Coatings / Dyco Paints • 5850 Ulmerton Road • Clearwater, FL 33760
Phone: 1-800-282-7901 • Facsimile: 727.536.0561 • www.SunPaintsAndCoatings.com
DYC9040
TUFF GRIP BONDING COAT
9040 Precautions & Application Guide
to three (2-3) hours @ 77°F (25°C) and 50% R.H.
Ready for topcoat in eight (8) hours. Low tempera-
ture, high humidity, thick lms or poor ventilation
will increase these dry times.
TOOLS & APPLICATORS / CLEANING: Phenolic
core (solvent resistant) medium nap roller, brush
or airless sprayer. Cleans up with soap and water.
WARNING! If you scrape, sand or remove old
paint, you may release lead dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY
IN CHILDREN. PREGNANT WOMEN SHOULD ALSO
AVOID EXPOSURE. Wear a NIOSH-approved respi-
rator to control lead exposure. Clean up carefully
with a HEPA vacuum and a wet mop. Before you
start, nd out how to protect yourself and your
family by contacting the National Lead Informa-
tion Hotline at 1-800-424-LEAD or log on to www.
epa.gov/lead.
CAUTION!
HARMFUL IF SWALLOWED. MAY CAUSE EYE,
SKIN AND RESPIRATORY IRRITATION. USE WITH
ADEQUATE VENTILATION. DO NOT TAKE INTER-
NALLY. KEEP CLOSED WHEN NOT IN USE. KEEP
OUT OF REACH OF CHILDREN.
CALIF. PROP. 65 • WARNING: This product con-
tains chemicals known to the State of California
to cause cancer, birth defects or other reproduc-
tive harm. Use proper protection and adequate
ventilation, when using product.
VOC: Contains less than 350 g/l as supplied.
Technical data is true and accurate at date of is-
suance, but subject to change without notice. Our
products conform to Sun Paints & Coating quality
standards, but no other warranty or guarantee is
expressed or implied. Liability, if any, is limited to
replacement of product or purchase price. Labor,
cost of labor, or consequential damages is hereby
excluded.
Material Safety Data Sheet available upon re-
quest.
FOR USE ON: Concrete and wood surfaces usu-
ally found in driveways, garages, walkways, patios,
pool decks, docks, steps and ramps.
PRECAUTION: Do not freeze. Wear protective
clothing and eyewear during application of this
product. Do not transport on passenger seats
or inside passenger compartment of any vehicle.
Store product in cargo area of vehicle, and se-
cure with protective cloths to prevent accidental
spill damage. Do not store at temperature above
100°F (37°C). Do not use in drinking water or food
systems.
READ AND FOLLOW ALL DIRECTIONS: Surfaces
must be clean, dry and sound. Contaminants
such as dirt, dust, grease, wax, oil, soap lm,
rust, mold, mildew, bond breakers and curing
compounds must be removed before application.
Loose, chipping and peeling of previous coating
must be removed before application. Repair holes
and cracks with an appropriate patching material.
Clean surfaces with bleach solution [one (1) part
bleach to four (4) parts water] and a stiff bristle
brush. If mildew is present, treat with a mildew
remover. Rinse with clean water and let dry one
(1) to two (2) days before application. Do not apply
to damp surfaces or when surface temperature is
below 50°F (10°C) or above 100°F (37°C). Do not
apply if rain is prevalent. Do not thin.
PREPARING NEW AND PREVIOUSLY COATED
SURFACES: Allow new exterior concrete to cure a
minimum of 30 days and a minimum of 45 days
for new interior concrete before application. Pres-
sure cleaning is recommended. Alternative to acid
etching.
APPLICATION: Mix thoroughly before use. TUFF
GRIP is a one (1) coat process. Apply one (1) coat
evenly with a phenolic core (solvent resistant) me-
dium nap roller, brush or airless sprayer. Do not
leave puddles or roller marks. Coverage is 250-
500 sq. ft./gal. depending on surface porosity
and application method. Top coat with concrete
stain or paint in a minimum of eight (8) hours to
a maximum of ve (5) days. Dries to touch in two
B-15
R-1i
  • Page 1 1
  • Page 2 2

Dyco DYC9040/5 User manual

Brand
Dyco
Model
DYC9040/5
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents