vitapur VRFK5Q User manual

Installation Instructions:

All Vitapur RO Systems have been pre-assembled and tested at the factory, and don’t

need to dis-assemble. If you want to check or replace the filter(s). The following steps

need to be implemented:

1. Unlock the Locking Tab by sliding it from the right to the left of the slot to ‘Unlock’

Position.

2. Lift the filter top section into the Head. Turn the filter about 1/4 turn in the direction as

shown in figure 1 until it stops.

3. Slide the Locking Tab from left to right of the slot to ‘Lock’ position.

1. Unlock the Locking Tab by sliding it from the right to the left of the slot to ‘Unlock’

Position.

2. Turn the filter in the direction as shown in figure 2 about 1/4 turn until it comes out of the

head.

NOTE: The filter head can be swung forward to assist in the filter installation.

CAUTION: Don’t attempt to turn the filter housing while in the ‘Lock’ position. It may

damage the system and cause leaks.

Installing the Quick Connect Filter (See Figure 1):

Un-installing the Quick Connect Filter (See Figure 2):

Figure 1. Figure 2.

1/4