ADJ Products Bubbletron Go User manual

Brand: ADJ Products

Model: Bubbletron Go

Type: User manual

User Instructions

12/15

BuBBletron Go

specications, diagrams, images, and instructions herein are

subject to change without notice. ADJ Products, LLC logo and

identifying product names and numbers herein are trademarks

of ADJ Products, LLC. Copyright protection claimed includes all

forms and matters of copyrightable materials and information

now allowed by statutory or judicial law or hereinafter granted.

Product names used in this document may be trademarks or

registered trademarks of their respective companies and are

hereby acknowledged. All non-ADJ Products, LLC brands and

product names are trademarks or registered trademarks of their

respective companies.

ADJ Products, LLC and all aliated companies hereby dis-

claim any and all liabilities for property, equipment, building,

and electrical damages, injuries to any persons, and direct or

indirect economic loss associated with the use or reliance of

any information contained within this document, and/or as a

result of the improper, unsafe, unsucient and negligent as-

sembly, installation, rigging, and operation of this product.

Europe Energy Saving Notice

Energy Saving Matters (EuP 2009/125/EC)

Saving electric energy is a key to help protecting the enviroment.

Please turn o all electrical products when they are not in use. To

avoid power consumption in idle mode, disconnect all electrical

equipment from power when not in use. Thank you!

ADJ Products, LLC www.adj.com Bubbletron Go Instruction Manual Page 3

Bubbletron Go Safety Precautions

• Keep the outside of this device dry at all times. Do not spill water

or other liquids into or on to your unit. Be sure all bubble juice is

kept inside the uid tray! To prevent re or shock hazard, do not

expose this product to rain or moisture.

• Do not spill water or other liquids into or on to your unit

• Do not attempt to operate this unit if the power cord has been fray-

ed or broken. Do not attempt to remove or break o the ground

prong from the electrical cord. This prong is used to reduce the risk

of electrical shock and re in case of an internal short

• Disconnect from main power before making any type of connection

• Do not remove the cover under any conditions. There are no user

serviceable parts inside

• Always be sure to mount this unit in an area that will allow proper

ventilation. Allow about 6” (15cm) between this device and a wall

• Do not attempt to operate this unit, if it becomes damaged

• This unit is intended for indoor use only, use of this product out-

doors voids all warranties

• During long periods of non-use, disconnect the unit’s main power

• Always mount this unit in safe and stable matter

• Power cords should be routed so they are not likely to be walked

on, pinched by items placed upon or against them.

• Heat -The appliance should be situated away from heat sources

such as radiators, heat registers, stoves, or other appliances (in-

cluding ampliers) that produce heat.

• The xture should be serviced by qualied service personnel when:

A. The power-supply cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the unit.

C. The unit has been exposed to rain or water.

D. The appliance does not appear to operate normally or exhibits a

marked change in performance.

Please carefully read and understand the instructions in this manual

thoroughly before attempting to operate this unit. These instructions

contain important safety information regarding the use and mainte-

nance of this unit. Please keep this manual with the unit, for future

reference.

Bubbletron Go General Instructions

ADJ Products, LLC - www.adj.com - Bubbletron Go Instruction Manual Page 2

Unpacking:

Thank you for purchasing the Bubbletron Go by ADJ Products, LLC.

Every Bubbletron Go has been thoroughly tested and has been shipped

in perfect operating condition. Carefully check the shipping carton for

damage that may have occurred during shipping. If the carton appears

to be damaged, carefully inspect your xture for any damage and be

sure all accessories necessary to operate the unit have arrived intact.

In the event damage has been found or parts are missing, please con-

tact our toll free customer support number for further instructions.

Please, do not return this unit to your dealer without rst contacting

customer support.

Instructions:

The Bubbletron Go is a portable battery powered bubble machine

capable of creating hundreds of bubbles a minute. This unit comes

with a wired On/O remote control with a 25ft. cable. To optimize the

performance of this product, please read these operating instructions

carefully to familiarize yourself with the basic operations of this unit. Be

sure you understand these instructions completely before attempting

to operate this unit.

Customer Support:

ADJ provides a toll free customer support line, to provide set up and

installation help and to answer any question should you encounter

problems during your set up or initial operation. You may also visit us

on the web at www.adj.com for any comments or suggestions. Toll

free customer service hours are Monday through Friday 8:00 a.m. to

4:30 p.m. Pacic Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2610

E-mail: [email protected]

To purchase parts online visit http://part.americandj.com

Warning! To prevent or reduce the risk of electrical shock or re, do

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

attempt to make any type of repair yourself without the manufactures

consent, doing so will void your manufactures warranty. In the unlikely

event your unit may require service please contact ADJ customer sup-

port for further instructions.

Bubbletron Go Introduction

ADJ Products, LLC www.adj.com Bubbletron Go Instruction Manual Page 4

• Battery Powered

• High velocity, high output fan

• Easy accessible front fluid tank

• High bubble output

• Low current draw

• Durable plastic casing

• Optional On/Off Remote Control

Bubbletron Go Features Bubbletron Go Operation

Bubbletron Go Product Registration

The Bubbletron Go carries a one year (365 days) limited warranty.

Please fill out the enclosed warranty card to validate your purchase.

All returned service items whether under warranty or not, must be

freight pre-paid and accompany a return authorization (R.A.) num-

ber. The R.A. number must be clearly written on the outside of the

return package. A brief description of the problem as well as the R.A.

number must also be written down on a piece of paper and included

in the shipping container. If the unit is under warranty, you must pro-

vide a copy of your proof of purchase invoice. You may obtain a R.A.

number by contacting customer support at (800) 322-6337.

ADJ Products, LLC - www.adj.com - Bubbletron Go Instruction Manual Page 5

Filling the Tray Reservoir:

1. Place the Bubbletron Go on a at level surface.

2. The bubble juice tray is located in the front of the machine. Fill the

tray, using premium American DJ

® brand bubble juice. Make sure

that you do not ll the tray above the designated ll line. Filling

above the line will result in damage to the machine. After the usage,

please empty the remaining juice to prevent damage as well.

Operation:

Once the tray has been lled, place the unit on at level surface. Flip

the power switch to the “ON” position and watch the bubbles come

out by the hundreds. Be sure the unit remains in a level position to

avoid accidental leaking.

Remote Operation (Optional):

The unit may be used with an optional on/o remote that can be used

to power on the Bubbletron Go regardless of the setting of the units

power switch.

Remote Operation:

1. Plug the remote control into the unit.

2. Push the power button on the remote to the “ON” position, main

power will be indicated by a glowing red LED above the remote

power button.

Battery Recharge:

It will take about 6 hours to reach full charge. To recharge the battery,

plug the supplied power supply into the input on the rear of the unit

and plug the other end into a matching power supply. A red LED on the

the power supply will glow indicating that the unit is charging. When

the unit reaches full charge a green LED will glow.

Bubbletron Go Battery Precautions

• Never charge batteries unattended. When charging batteries you

should always remain in constant observation to react to any

potential problems that may occur.

• If at any time you witness a battery starting to smoke, get hot, or

abnormal smell, discontinue the charging process immediately.

Disconnect the power supply and observe the unit in a safe place

for approximately 15 minutes. The battery could end up leaking

and the reaction with air may cause the chemicals to ignite, resulting

in a re.

• Neve store or charge battery pack inside your car in extreme tem-

peratures, since this could ignite a re.

• Neve transport or store battery pack in high temperature enviro-

ment for a long time.

MODEL: BUBBLETRON GO

VOLTAGE: DC 12V 1000mA

POWER CONSUMPTION: 17W

DIMENSIONS:

13.75” x 7” x 8.25”

352 x 176 x 209mm

WEIGHT:

5Lbs. / 2.1 kgs

WORKING POSITION: FLAT LEVEL POSITION

FLUID TANK: 1 Liter

FLUID CONSUMPTION RATE: 1 LITER. Every 50 Mins

BATTERY CHARGE TIME: 6 Hours

BATTERY LIFE: 5 Hours (fuLL on)

COOLING: FAN COOLED

DUTY CYCLE: NONE

Please Note: Specications and improvements in the design

of this unit and this manual are subject to change without any

prior written notice.

Bubbletron Go Specifications

ADJ Products, LLC

6122 S. Eastern Ave. Los Angeles, CA 90040 USA

Tel: 323-582-2650 / Fax: 323-725-6100

Web: www.adj.com / E-mail: [email protected]

A.D.J. Supply Europe B.V.

Junostraat 2

6468 EW Kerkrade

The Netherlands

[email protected] / www.adj.eu

Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99

Bubbletron Go Warranty

MANUFACTURER’S LIMITED WARRANTY

A. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products

to be free of manufacturing defects in material and workmanship for a prescribed period from

the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the

product is purchased within the United States of America, including possessions and

territories. It is the owner’s responsibility to establish the date and place of purchase by acceptable

evidence, at the time service is sought.

B. For warranty service you must obtain a Return Authorization number (RA#)

before sending back the product–please contact ADJ Products, LLC Service Department

at 800-322-6337. Send the product only to the ADJ Products, LLC factory. All

shipping charges must be pre-paid. If the requested repairs or service (including

parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return

shipping charges only to a designated point within the United States. If the entire instrument is

sent, it must be shipped in it’s original package. No accessories should be shipped with the product. If

any accessories are shipped with the product, ADJ Products, LLC shall have no liability whatsoever for

loss of or damage to any such accessories, nor for the safe return thereof.

C. This warranty is void if the serial number has been altered or removed; if the product is modified in any

manner which ADJ Products, LLC concludes, after inspection, affects the reliability of the product; if the

product has been repaired or serviced by anyone other than the ADJ Products, LLC factory unless prior

written authorization was issued to purchaser by ADJ Products, LLC; if the product is damaged because

not properly maintained as set forth in the instruction manual.

D. This is not a service contract, and this warranty does not include maintnance, cleaning or periodic check

up. During the period specified above, ADJ Products, LLC will replace defective parts at its expense

with new or refurbished parts, and will absorb all expenses for warranty service and repair labor by

reason of defects in material or workmanship. The sole responsibility of ADJ Products, LLC under this

warranty shall be limited to the repair of the product, or replacement thereof, including parts, at the sole

discretion of ADJ Products, LLC. All products covered by this warranty were manufactured after August

15, 2012, and bear indentifying marks to that effect.

E. ADJ Products, LLC reserves the right to make changes in design and/or improvements upon its products

without any obligation to include these changes in any products theretofore manufactured.

No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with

products described above. Except to the extent prohibited by applicable law, all implied warranties made

by ADJ Products, LLC in connection with this product, including warranties of merchantability or fitness,

are limited in duration to the warranty period set forth above. And no warranties, whether expressed or

implied, including warranties of merchantability or fitness, shall apply to this product after said period

has expired. The consumer’s and/or Dealer’s sole remedy shall be such repair or replacement as is

expressly provided above; and under no circumstances shall ADJ Products, LLC be liable for any loss or

damage, direct or consequential, arising out of the use of, or inability to use, this product.

This warranty is the only written warranty applicable to ADJ Products, LLC Products and

supersedes all prior warranties and written descriptions of warranty terms and conditions heretofore

published.

MANUFACTURER’S LIMITED WARRANTY PERIODS:

 •LightingProducts=1-year(365days)LimitedWarranty(Such as: Special Effect Lighting, Intelligent

Lighting, UV lighting, Strobes, Fog Machines, Bubble Machines, Mirror Balls, Par Cans, Trussing,

Lighting Stands etc. excluding LED and lamps)

 •LaserProducts=1Year(365Days)LimitedWarranty(excluding laser diodes which have a 6 month

limited warranty)

 •L.E.D.Products=2-year(730days)LimitedWarranty(excluding motors, PCB boards, and power

supplies, which have a 1-year (365 day Limited Warranty) batteries which have a 180 day limited war-

ranty). Only the L.E.D.s carry a 2-year warranty (excludingStarTecSerieswhichacarriesa1Year

LimitedWarranty)

•ADJDMXControllers=2Year(730Days)LimitedWarranty(excluding faders and tact switches)

ADJ Products, LLC - www.americandj.com - Bubbletron Go Instruction Manual Page 6

ADJ Products Bubbletron Go User manual

ADJ Products Bubbletron Go User manual

ADJ Products Bubbletron Go User manual

Related papers

Other documents